Toyspeed.org.nz Message Board

by **sk1dlet** » Tue Jul 27, 2010 9:57 pm

can anybody tell me wat the back inside diameter of a 13 inch hotwire is as im considering some for a starlet but it has to clear my s13 rotors and callipers

OMG so shiny! · by **Dell'Orto** » Tue Jul 27, 2010 9:57 pm

Can you be more specific?

by **frost** » Tue Jul 27, 2010 10:02 pm

depends what make of hotwire you buy,
best to test fit first,

by **sk1dlet** » Tue Jul 27, 2010 10:05 pm

well the inside circumference need to be at least 305-310mm to clear my callipers

OMG so shiny! · by **Dell'Orto** » Tue Jul 27, 2010 11:15 pm

Well that oughtnt be a problem, 310mm is just over 12". Might need to be careful where balancing weights are attached though :lol:

by **rollaholic** » Wed Jul 28, 2010 8:44 am

say no to hotwires

by **spannersnz** » Thu Jul 29, 2010 9:56 am

Im selling some hotties, were on my starlet. If you want I can measure the backs up tonight? 027 305 4261

by **frost** » Thu Jul 29, 2010 11:35 pm

rollaholic wrote:say no to hotwires

QFT

if you find some enkie hotwires (there more mesh then hotwire) they have alot of space for big brakes,

my friend was selling the silvia brake kit for the starlet ages ago, and im sure you still need spaces cos the front of the caliper will hit the back of the rim face,

by **spannersnz** » Fri Jul 30, 2010 1:03 am

FYI

I measured my chevoit hotties tonight. Where the rim meets the wheel face it is about 300mm, but the back outer lip is about 320.

Toyspeed.org.nz Message Board

13" hotwires

13" hotwires

Who is online