Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Bosch 044 install tips please.

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Bosch 044 install tips please.

Postby BlakeNZ » Mon Aug 16, 2010 7:50 am

If i am installing a 044 intank on a soarer, will i need to upgrade the wiring or add a relay, or will the current draw be similar to the present walbro 341 that is in there?
former car 1991 JZZ30 soarer 1JZGTE 11.5sec@122mph(stock turbos,E85)
current car 1993 JZZ30 soarer (Golden Boy)
BlakeNZ
Toyspeed Member
 
Posts: 625
Joined: Thu Oct 03, 2002 1:53 pm
Location: Palmerston Nth
Top

Postby Heylin » Mon Aug 16, 2010 1:57 pm

I had a SARD 280LPH pump installed to MR2 and they used the stock wiring. I suppose if your wiring is deteriorated then yeah.
Heylin
Heylin
Toyspeed Member
 
Posts: 682
Joined: Sun Mar 23, 2003 11:37 am
Top

Postby Py7h0n » Tue Aug 17, 2010 3:34 pm

044 draws a lot more than a Walbro. It would be best to run seperate wiring triggered by a relay off the factory wiring.
User avatar
Py7h0n
Toyspeed Member
 
Posts: 413
Joined: Wed Aug 06, 2003 5:28 pm
Location: North Shore, Auckland
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 14 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.018s | 11 Queries | GZIP : On