3SFE oil filter

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

3SFE oil filter

Postby redline racer » Wed May 09, 2012 1:44 pm

Hi all, have noticed the oil light on my 3sfe st202 celica is a bit slow to go off on cold start.

It is due for a oil change and was wondering if it would be worthwhile fitting a toyota oil filter.(currently has a ryco) Have been told factory oil filters hold better oil pressure? unsure weather to believe this or not. factory filter is $30 Ryco is $13 so you would hope there would be some difference? car has done 160k so im not expecting a miricle cure but if it helps its worth a shot possibly?
redline racer
Toyspeed Member
 
Posts: 182
Joined: Sun Jan 04, 2004 7:59 pm
Location: Hastings

Postby Burning Angel » Wed May 09, 2012 4:33 pm

rycos arent bad filters.

The thing that most affects oil flow when cold is what type of oil you have in it(ie. 15w40 10w40 etc)

Also 3s engines have the oil pressure sensor in the head, not the block like most engines(at least 3sg engines do, not sure about 3sf) so the oil light tends to take longer to turn off.
1984 SRP61 Starlet
1999 WRX Type RA
User avatar
Burning Angel
Toyspeed Member
 
Posts: 457
Joined: Wed Aug 17, 2005 11:21 am
Location: Dunedin

Postby MAC_HATER » Wed May 09, 2012 5:11 pm

my 3S-GE celica did that - it scared the shite out of me as i knew what 3S-GE's did when oil was starved

i changed from a ryco oil filter to a donaldson and it helped a fiar bit - was 15 seconds till the oil light went away down to about 4-6 seconds with the donaldson oilfilter

my engine was probably half shot anyway - but the donaldson oil filter did help it seems
Image
~SlideWays~: Cars + Males = Single, therefore: Poptarts?
User avatar
MAC_HATER
Toyspeed Member
 
Posts: 1071
Joined: Tue Oct 26, 2010 10:35 am
Location: Invercargill

Re: 3SFE oil filter

Postby sergei » Wed May 09, 2012 6:16 pm

redline racer wrote:Hi all, have noticed the oil light on my 3sfe st202 celica is a bit slow to go off on cold start.

It is due for a oil change and was wondering if it would be worthwhile fitting a toyota oil filter.(currently has a ryco) Have been told factory oil filters hold better oil pressure? unsure weather to believe this or not. factory filter is $30 Ryco is $13 so you would hope there would be some difference? car has done 160k so im not expecting a miricle cure but if it helps its worth a shot possibly?


Factory filter is $22 from Mark (I1I) TS TGP sponsor. It definitely solved cold start up rattle on high km 20v.
User avatar
sergei
Mad Russian
 
Posts: 8406
Joined: Wed May 15, 2002 12:06 pm
Location: North Shore

Postby Mr Revhead » Wed May 09, 2012 7:05 pm

Some after market drain back valves are a bit..... well shit really.
Was very common on the old ryco 191as, but they are well gone now!
386 should be ok.
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby redline racer » Thu May 10, 2012 10:06 pm

thanks for all the replies 8)

think i'll give the toyota filter a shot.

Iam using 15w-40. it burns a bit and needs checking every few weeks which i thought is strange, But I used to have a 60km levin bzv and that burnt oil too. have never noticed the celica visually smoking so must be at high rpm only. although it only gets high rpm now and then if passing etc otherwise just normal driving..
redline racer
Toyspeed Member
 
Posts: 182
Joined: Sun Jan 04, 2004 7:59 pm
Location: Hastings

Postby Mr Ree » Fri May 11, 2012 11:15 am

Why not try going to a thinner grade of oil at the same time as changing your filter?

I dont know what toyota recommend you use for your motor but my 5sfe gets 10w-40 and the oil light is off in a few seconds from stone cold
wak thud gush!
User avatar
Mr Ree
Toyspeed Member
 
Posts: 2758
Joined: Wed Nov 17, 2010 6:51 pm
Location: On the South coast where the tui's sing tututu.


Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 24 guests

cron