Came across this on Trademe:
http://www.trademe.co.nz/motors/car-par ... 974839.htm
The guy reckons its a factory Toyota A to W bellhousing. I thought they were only available aftermarket? Has he got his wires crossed or is it legit? I asked him last time and he was pretty adamant about it.
Factory 4age to W55 bellhousing?
Moderator: The Mod Squad
11 posts
• Page 1 of 1
Factory 4age to W55 bellhousing?
by Hachiroku » Wed Jul 18, 2012 11:07 pm
Last edited by Hachiroku on Thu Jul 19, 2012 12:58 am, edited 1 time in total.
- Hachiroku
- Toyspeed Member
- Posts: 386
- Joined: Sat Aug 31, 2002 6:05 pm
- Location: Auckland
by Dell'Orto » Wed Jul 18, 2012 11:21 pm
Doesnt look like a 4A pattern to me, might be an M or G.
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
-
Dell'Orto - ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 5:07 am
- Location: Straight out the ghetto, Lower Hutt
-
QikStarlie - Toyspeed Member
- Posts: 1110
- Joined: Tue Mar 25, 2003 10:30 pm
- Location: lost..
by thegreatestben » Thu Jul 19, 2012 12:05 am
Didn't we figure out that it should have the correct designation stamped in the mounting face?
-
thegreatestben - Toyspeed Member
- Posts: 2083
- Joined: Sat Aug 26, 2006 5:09 am
- Location: Lower Hutt
by thegreatestben » Thu Jul 19, 2012 1:02 am
matt dunn wrote:Interesting thing if found the other day,
all the w series bellhousings are labelled on the surface that mounts to the gearbox, so if you remove the housing there is a letter in there.
I now know the mystery bellhousing I have is an L series diesil one.
-
thegreatestben - Toyspeed Member
- Posts: 2083
- Joined: Sat Aug 26, 2006 5:09 am
- Location: Lower Hutt
by wde_bdy » Thu Jul 19, 2012 8:54 am
If it actually comes close to lining up on a 4A then it is likely to be a K -W bell, I have a K - T that has been redrilled for A series. Well it will actually be a K to G but they bolt up the same a W's, from a Liteace van.
Callum
Callum
-
wde_bdy - Toyspeed Member
- Posts: 2704
- Joined: Wed Oct 23, 2002 11:43 pm
- Location: Gisborne
by AE86less » Thu Jul 19, 2012 7:21 pm
What engine is it referring to if it just says 2? Where one says wxjz, this one says 2 
AE85.5
1GGZE GX81
D21 Navara K/C
1GGZE GX81
D21 Navara K/C
Alex B wrote:To be fair you're never going to fit into OS unless you hate on TS.
-
AE86less - Mo' Fail
- Posts: 2198
- Joined: Wed Oct 19, 2005 1:15 pm
- Location: North Shore, Auckland
by matt dunn » Thu Jul 19, 2012 8:23 pm
AE86less wrote:What engine is it referring to if it just says 2? Where one says wxjz, this one says 2
sure it's not an S instead of a 2 ??
I have seen some that dont have anything also.
- matt dunn
- Toyspeed Member
- Posts: 7109
- Joined: Fri Sep 12, 2003 1:01 am
- Location: Timaru
by AE86less » Thu Jul 19, 2012 9:38 pm
I'm not sure, I don't have it on me. I'm pretty sure the guy can read though 
Maybe when I get it back I'll post up a pic...
Maybe when I get it back I'll post up a pic...
AE85.5
1GGZE GX81
D21 Navara K/C
1GGZE GX81
D21 Navara K/C
Alex B wrote:To be fair you're never going to fit into OS unless you hate on TS.
-
AE86less - Mo' Fail
- Posts: 2198
- Joined: Wed Oct 19, 2005 1:15 pm
- Location: North Shore, Auckland
11 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 46 guests