Altezza quad throttle

[petrolhead]

Hey guys.
Does anyone know if any company makes a bolt on Q.T.B setup for 3sge beams. Trying to determine setup on my bros car.

Thanks

[fivebob]

Besides TRD which uses modified 20v throttle bodies, there is Alloy Race Components In Aus. http://www.alloyrace.com/products/c13/Custom-Inlet-Manifolds

[Celica RA45]

and me i make 48mm and 50mm quad throttle set ups as well for the black top beams motors

[andrewgreen1000]

I read somewhere on another car forun that its not too hard to use the quads from a sr20det Gtir pulsar. could be worth looking into?

[gmacrae]

i imagine its not hard to do, but very hard to improve on the stock manifold

[Celica RA45]

if you guys send me a e-mail will send you guys some pics of my set ups for the altezza 3sge motors
e-mail addy is gbooth@bigpond.net.au

[petrolhead]

Hi guys thanks for replys. The car already has quad throttles on it, i was trying to determine there origin. It would seem as they are TRD items as is half the other aftermarket stuff on the car

[Celica RA45]

the trd 1s are only black top throttles which are 45mm butterflys

[stoffa]

sorry to bring up an old thread, but im new to NA ownership (just swapped my wrx for an RS200)
Can you run quad throttle bodies on the standard Altezza ECU without drama?

[Mr Ree]

Hello Mr Stoffa

Good to see you have stepped into the over engineered world of Toyota hehe.

Im off to Manfeild in a few hours, hope to share the track with you once your car is ready

[stoffa]

Haha I was meant to be there tomorrow but swapped the wrx yesterday

[QikStarlie]

itb's will need an aftermarket ecu to run properly