Cynos B idle too fast and poor heat output - thermostat ?

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Cynos B idle too fast and poor heat output - thermostat ?

Postby markoneswift » Mon Jun 10, 2013 10:27 am

Hey all, I've just picked up this little Cynos B as a run about and first thing I noticed is it takes ages to warm up and the idle is ( I assume ) too high - she idles at around 1200-1300 rpm most of the time.
I'm a Toyota novice ( first time owner ) but I have a reasonable amount of mechanical knowledge so I'm thinking maybe the thermostat might be stuck open. Is this common on this age of Toyota and is it easy / cheap to fix ? Thanks !
markoneswift
Toyspeed Member
 
Posts: 87
Joined: Sat Jun 08, 2013 6:43 pm
Location: Hamilton

Postby Dell'Orto » Mon Jun 10, 2013 10:43 am

Quite common on cars that have had little to no servicing. Cheap and easy to replace at least!
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!

Quint wrote:Not just cock, large cock.
User avatar
Dell'Orto
** Moderator **
 
Posts: 17494
Joined: Tue Jul 08, 2003 5:07 am
Location: Straight out the ghetto, Lower Hutt

Postby markoneswift » Mon Jun 10, 2013 1:48 pm

Dell'Orto wrote:Quite common on cars that have had little to no servicing. Cheap and easy to replace at least!


Can you give me some pointers on where to get a replacement ( there's a Supercheap Autos near me ? ) and also where it is located on the 5-FHE engine ? Cheers
markoneswift
Toyspeed Member
 
Posts: 87
Joined: Sat Jun 08, 2013 6:43 pm
Location: Hamilton

Postby Grrrrrrr! » Mon Jun 10, 2013 2:08 pm

I'd tend to go to toyota, i've never had any luck with tridon brand thermostats. Get the rubber sealing ring/gasket too.

Follow the hose going to the top of the radiator back to the end of the engine. Thermostat is inside where that hose goes back to. Two bolts to undo IIRC.
Reality: A nasty hallucination that is caused by excess blood in the alcohol stream.
Grrrrrrr!
Toyspeed Member
 
Posts: 2566
Joined: Tue Jun 17, 2003 7:21 pm
Location: Souf Orkland

Postby RobertC » Mon Jun 10, 2013 3:13 pm

There is a sponsors section on the forum, have a look at the details for Toyota. (Mark will sort you out with a genuine Toyota thermostat)


This sort of shows where it is.

Passengers end of the engine.

Image
MRAE111 wrote:ok thanks guys but wen u dont have trmpets i think the air flow quickeer into the throttle bodies
User avatar
RobertC
Toyspeed Member
 
Posts: 493
Joined: Sat Jun 19, 2010 11:35 am
Location: Auckland

Postby Leon » Mon Jun 10, 2013 5:40 pm

agreed with the go Toyota suggestion ... more than half the time I've gone Repco bits, I've had to replace them again due them not working. Dunno why, it's only a freakin thermostat.
User avatar
Leon
Toyspeed Member
 
Posts: 6642
Joined: Wed Feb 26, 2003 6:27 pm
Location: Wellington

Postby Lloyd » Mon Jun 10, 2013 6:51 pm

3rd/4th'd for going to Toyota directly. They aren't a lot more expensive, and you should have more success. 2 bolts on the housing at the gearbox end of the head and you're done.
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin

Postby Mr Revhead » Mon Jun 10, 2013 8:08 pm

At least Toyota will sell you the right gasket and not some generic thing that fits nothing
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby rollaholic » Mon Jun 10, 2013 8:12 pm

thats not true, i've used those generic gaskets on an old falcon once. and maybe on like a cherokee or something :P
BASU!
User avatar
rollaholic
Toyspeed Member
 
Posts: 5383
Joined: Fri May 28, 2004 2:19 am
Location: West is Best

Postby Mr Revhead » Mon Jun 10, 2013 8:15 pm

I once fixed my old XA with wire and a hammer
Being the subject of E-whinges since 2004 8)

http://www.centralmotorsport.org.nz/home

Image
User avatar
Mr Revhead
SECURITY!
 
Posts: 24635
Joined: Tue Jan 20, 2004 4:06 pm
Location: Nelson

Postby Akane » Mon Jun 10, 2013 10:03 pm

I had a 4E-FE Corolla, which is the same family as your cyno's 5E-FHE, which had a stuck thermostat too.
No "stance", no "hellaflush", none of that bullshit. Nothing but no grip on full boost.
http://www.lol.co.nz/ random shit.
User avatar
Akane
Toyspeed Member
 
Posts: 4073
Joined: Tue May 14, 2002 2:08 am
Location: Auckland

Postby allencr » Mon Jun 10, 2013 10:30 pm

I'd get Toyota thermostats IF, I also got Toyota oil, tyres, belts, batteries, filters, bearings, wiper blades and spark plugs.
allencr
Toyspeed Member
 
Posts: 346
Joined: Thu Dec 04, 2008 9:02 am
Location: Talahassee, Florida USofA

Postby markoneswift » Mon Jun 10, 2013 10:47 pm

Awesome thanks for the info guys - no need to move the dizzy to get to the stat then ?
markoneswift
Toyspeed Member
 
Posts: 87
Joined: Sat Jun 08, 2013 6:43 pm
Location: Hamilton

Postby Lloyd » Mon Jun 10, 2013 11:13 pm

allencr wrote:I'd get Toyota thermostats IF, I also got Toyota oil, tyres, belts, batteries, filters, bearings, wiper blades and spark plugs.


Toyota thermostats, spark plugs, filters and belts (in some cases) are cheaper than the aftermarket alternatives over here so it makes more sense. And the quality of the thermostats is significantly better than the other options also.
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin

Postby AE82 FXGT » Tue Jun 11, 2013 6:22 pm

Lloyd wrote:
Toyota thermostats, spark plugs, filters and belts (in some cases) are cheaper than the aftermarket alternatives over here so it makes more sense. And the quality of the thermostats is significantly better than the other options also.


Toyota thermostats are awesome, I've had nothing but problems with Tridon thermostats (3 to be exact, I don't learn quick do I?), I'd rather pay a bit more and do the job once.
Previous: '85 AE82 FXGT, '92 AE101 GTZ, '92 AE101 GT-APEX, '04 SE3P RX8, '05 Mazda 6 MPS, '97 NA8C MX5, '03 GSX250, '08 ZX6R, '13 GROM
Current: '07 GRE156 BLADE MASTER G
User avatar
AE82 FXGT
Toyspeed Member
 
Posts: 1594
Joined: Thu Nov 04, 2004 1:51 pm
Location: Lower hutt

Postby Garreth27 » Tue Jun 11, 2013 8:42 pm

no need to move dizzy to get to it
Current Rides:
91 Gt Starlet - Forged 5efte Drag Toy
88 EP71 Turbo S Starlet Track Toy
99 SEX10 Altezza - Daily Driver
User avatar
Garreth27
Toyspeed Member
 
Posts: 315
Joined: Sun Aug 26, 2007 11:07 am
Location: Massey, Waitakere

Postby markoneswift » Tue Jun 11, 2013 9:42 pm

Garreth27 wrote:no need to move dizzy to get to it


Ok thanks mate - turns out my Cynos B has the 5E-FHE engine which is supposed to be the best one in the series isn't it ?
markoneswift
Toyspeed Member
 
Posts: 87
Joined: Sat Jun 08, 2013 6:43 pm
Location: Hamilton

Postby siren676 » Tue Jun 11, 2013 9:44 pm

Its the best n/a E series engine, 4e-fte has a bit more power.
1998 5dr Glanza V Replica - 5E-FHE powered

1990 Mazda MX5 NA6C drift build - Met a wall 2/5/15
User avatar
siren676
Toyspeed Member
 
Posts: 1015
Joined: Sun Jun 13, 2010 1:47 pm
Location: South Auckland

Postby Lloyd » Tue Jun 11, 2013 9:47 pm

5E is the 1500 varient of the E series blocks, "F" is the narrow/economy version of the twin cam head design that Toyota use, "H" is for higher compression version, and "E" defines fuel injection.

Very few Toyota engines get the H tag in their name. And yeah it's the pick of the bunch in the E blocks (without a turbo). Pretty sure the Cynos A only got the 5E-FE, Cynos B got the 5E-FHE.
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin

Postby siren676 » Tue Jun 11, 2013 10:57 pm

Yeah i think that's right, i got my starlets 5e-fhe out of a Cynos B
1998 5dr Glanza V Replica - 5E-FHE powered

1990 Mazda MX5 NA6C drift build - Met a wall 2/5/15
User avatar
siren676
Toyspeed Member
 
Posts: 1015
Joined: Sun Jun 13, 2010 1:47 pm
Location: South Auckland

Next

Return to Tech Questions

Who is online

Users browsing this forum: Google [Bot] and 8 guests