1UZ-FE VVTI Surf conversion - stuck in 'limp mode'

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Re: 1UZ-FE VVTI Surf conversion - stuck in 'limp mode'

Postby KinLoud » Mon Dec 23, 2013 8:01 am

Classic shoot myself in the foot error when I put a gen 3 3sge into my AA63 Carina
Wrongly connected the ECU wire that monitors if the starter motor is running (wrong connector on the ignition switch)
ECU retards timing during starting - I connected it to constant 12v so ECU retarded timing permanently.
Idled fine but had no power.
I used to think that the orange and green tictacs gave you special powers. The orange ones would make you stronger and the green ones would make you faster. So i used to eat some green ones and run around my lounge as fast as i could, then eat the orange ones and try to pick up the sofa. I wish it were true!
User avatar
KinLoud
** Moderator **
 
Posts: 2893
Joined: Thu May 16, 2002 7:39 pm
Location: Auckland

Previous

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 25 guests

cron