Sitting Full Licence

General discussions on all non technical car related topics

Moderator: The Mod Squad

Sitting Full Licence

Postby eritate » Thu Sep 07, 2006 12:43 pm

Hey guys (dunno if this is in the right thread or not)

Im sitting my Full Licence next week on the 13th of sep :)

Im curious as to what happens

Ive got the outlining paper here from LTSA and also been told by a few mates of what goes on.

What are your guys experiences and tips ?

Also with the hazard identfication.... Do you have to say everything while your driving or does the tester make you pull over and repeat everything you saw?

Is there much open road driving eg overtaking etc?

Cheers a lot

Mike
I am a timewaster. Ignore anything I say
User avatar
eritate
Toyspeed Member
 
Posts: 736
Joined: Thu Feb 17, 2005 9:14 pm
Location: Palmy North

Re: Sitting Full Licence

Postby bluemaumau » Thu Sep 07, 2006 12:56 pm

eritate wrote:What are your guys experiences and tips ?


when doing the u turn indicate over to the side of the road, he will talk to you. then cheack front rear, blindspots etc, and indicate out.

eritate wrote:Also with the hazard identfication.... Do you have to say everything while your driving or does the tester make you pull over and repeat everything you saw?


they did both for me, twice while driving, once for the recall

eritate wrote:Is there much open road driving eg overtaking etc??


i suppose if someone was driving well under the limit you could overtake them. also remember when hitting the open road, that you need to accelerate cleanly quickly, i got warned for reachin 80kph to slowly!
4AGTE AE101 COROLLA - 90%

Where the $&#$% is that oil leak coming from /club

looking for enkei RP01 center caps (white)
User avatar
bluemaumau
Toyspeed Member
 
Posts: 4087
Joined: Sun Oct 16, 2005 7:08 pm
Location: SYDNEY, NSW

Postby eritate » Thu Sep 07, 2006 12:59 pm

sweet are you allowed to drive round in 4th in town ? at 50km ??

if u are allowed when u hit the 100km sign can u drop it into 3rd gear and accelerate or do you have to leave it in 4th ?
I am a timewaster. Ignore anything I say
User avatar
eritate
Toyspeed Member
 
Posts: 736
Joined: Thu Feb 17, 2005 9:14 pm
Location: Palmy North

Postby bluemaumau » Thu Sep 07, 2006 1:00 pm

i used a auto cause you are allowed in your full test, makes it a $&#$% load easier.
4AGTE AE101 COROLLA - 90%

Where the $&#$% is that oil leak coming from /club

looking for enkei RP01 center caps (white)
User avatar
bluemaumau
Toyspeed Member
 
Posts: 4087
Joined: Sun Oct 16, 2005 7:08 pm
Location: SYDNEY, NSW

Postby eritate » Thu Sep 07, 2006 1:05 pm

i guess it would make it easier...

is there a therory test ? did you have to do any parking ?
I am a timewaster. Ignore anything I say
User avatar
eritate
Toyspeed Member
 
Posts: 736
Joined: Thu Feb 17, 2005 9:14 pm
Location: Palmy North

Postby flat_0ut » Thu Sep 07, 2006 1:08 pm

take a look in the back of the road code, that should have some answers :wink: . It's mainly just making sure you are a confident and safe driver and alot of it is pointing out hazards.
User avatar
flat_0ut
Toyspeed Member
 
Posts: 389
Joined: Thu Apr 27, 2006 9:41 pm
Location: Auckland

Postby bluemaumau » Thu Sep 07, 2006 1:08 pm

well the theory is the recalling/pointing out obstacles etc.

only where i picked up/droped the tester off
4AGTE AE101 COROLLA - 90%

Where the $&#$% is that oil leak coming from /club

looking for enkei RP01 center caps (white)
User avatar
bluemaumau
Toyspeed Member
 
Posts: 4087
Joined: Sun Oct 16, 2005 7:08 pm
Location: SYDNEY, NSW

Postby eritate » Thu Sep 07, 2006 1:11 pm

cheers blue :D

cant find my road code:(

do they pop random questions out of the blue from the road code?
I am a timewaster. Ignore anything I say
User avatar
eritate
Toyspeed Member
 
Posts: 736
Joined: Thu Feb 17, 2005 9:14 pm
Location: Palmy North

Postby trueno_20v » Thu Sep 07, 2006 1:22 pm

just make sure you talk HEAPS about what your doing etc..
ADMIN EDIT: signature too large
User avatar
trueno_20v
Toyspeed Member
 
Posts: 589
Joined: Wed Aug 10, 2005 9:12 pm

Postby NA Drifter » Thu Sep 07, 2006 1:34 pm

Just make sure you don't do hand brake turn. I failed my 1st test cos of that. :?

On 100km/h zone, there is road work and 30km/h sign is up for a few K's and I got a lot of angry look from many other drivers which pass me when I'm doing 40km/h in 30km/h zone... :?
Keith
http://toyspeed.blakjak.net/profiles/profile.php?id=404

Austin Mini with 1275,TT140 Corona GT-TR with 3TGTEU, TE71 GT Levin with 2TGEU, AE86 Trueno 4AGE, AE85 Trueno 3A, Hilux Surf with 2JZGEU
User avatar
NA Drifter
Toyspeed Member
 
Posts: 1624
Joined: Thu Jul 25, 2002 2:43 pm
Location: Palmerston North

Postby eritate » Thu Sep 07, 2006 1:37 pm

NA Drifter wrote:Just make sure you don't do hand brake turn. I failed my 1st test cos of that. :?

On 100km/h zone, there is road work and 30km/h sign is up for a few K's and I got a lot of angry look from many other drivers which pass me when I'm doing 40km/h in 30km/h zone... :?


but i wana get my drifting licence :twisted:

i hate going slow in road works when everyone else wants to go fast :( i feel as though im letting everyone down LOL

Anyways cheers bud
I am a timewaster. Ignore anything I say
User avatar
eritate
Toyspeed Member
 
Posts: 736
Joined: Thu Feb 17, 2005 9:14 pm
Location: Palmy North

Postby 2LTR Rona » Thu Sep 07, 2006 1:39 pm

A lot will depend on the licensing officer you get, as to what they have you do & what they leave out.

As an example, when I sat my full licence we basically followed the same / similar route to that when doing the restricted with a few more things added in. Just remember the “basics” i.e coming to a COMPLETE stop at stop signs etc and it should be fine

As for what gear you are in while driving around, that is totally up to you, just make sure you don’t go over the allowed speed limit or take a “half chance” gap in traffic.

On the identifying hazards, all mine where asked to be noted from when the instructor / licensing office said “start” till he then said “stop”, we then pulled over and I identified them to him, don’t get too hung up on trying to remember everything, get the obvious ones & ya should be sweet, sometimes they will even give you hints to help.

And no they don’t pop questions from the road code while driving as you should already know the rules, this is about applying those rules to a practical situation, hence the practical test.

Just take it as another drive on any other day, be confident in what you are doing & you’ll fly through it
2002 Altezza, 1974 KE25

www.hccc.org.nz
User avatar
2LTR Rona
Toyspeed Member
 
Posts: 1903
Joined: Wed Aug 11, 2004 3:43 pm
Location: Wellington

Postby NA Drifter » Thu Sep 07, 2006 1:40 pm

Just be a good driver and obey all the law, always take notice around you when you drive, look at the mirrors alot expecially the rear view mirror. indicate atleast 3 sec before you need to turn and turn it off after 3 sec if the thing still on etc.
Then you should pass with flying colour! good luck and don't crash!
Keith
http://toyspeed.blakjak.net/profiles/profile.php?id=404

Austin Mini with 1275,TT140 Corona GT-TR with 3TGTEU, TE71 GT Levin with 2TGEU, AE86 Trueno 4AGE, AE85 Trueno 3A, Hilux Surf with 2JZGEU
User avatar
NA Drifter
Toyspeed Member
 
Posts: 1624
Joined: Thu Jul 25, 2002 2:43 pm
Location: Palmerston North

Postby MrOizo » Thu Sep 07, 2006 1:40 pm

eritate wrote:
i hate going slow in road works when everyone else wants to go fast :( i feel as though im letting everyone down LOL


If you like speeding through road works then dont complain when they have to rip the seal up again and again. the main point about going slow when new chipseal is down is for it to be bedded in.

And rememebr - the're reflective jackets, not bullet proof vests :)
User avatar
MrOizo
Toyspeed Legend
 
Posts: 6658
Joined: Thu May 16, 2002 9:26 pm
Location: Onehunga, Auckland

Postby MrOizo » Thu Sep 07, 2006 1:40 pm

oh yeah - and if you go through a stop sign. then stop!
User avatar
MrOizo
Toyspeed Legend
 
Posts: 6658
Joined: Thu May 16, 2002 9:26 pm
Location: Onehunga, Auckland

Postby no_8wire » Thu Sep 07, 2006 1:46 pm

dont go over 20kmhr in a carpark...dont do burn outs....dont race other cars...thats it I think!
User avatar
no_8wire
Toyspeed Member
 
Posts: 2268
Joined: Thu Dec 30, 2004 7:30 pm

Postby 2LTR Rona » Thu Sep 07, 2006 1:48 pm

MrOizo wrote:oh yeah - and if you go through a stop sign. then stop!


if you have gone through a stop sign isn't a little bit too late :P (i know what you were meaning)
2002 Altezza, 1974 KE25

www.hccc.org.nz
User avatar
2LTR Rona
Toyspeed Member
 
Posts: 1903
Joined: Wed Aug 11, 2004 3:43 pm
Location: Wellington

Postby Distrb » Thu Sep 07, 2006 2:11 pm

If you can drive to the letter of the law and can show the instructor that you're aware of what is going on around you, then you will have no issues passing the test.
www.hccc.org.nz 1986 Fx-Gt; 1999 Altezza
User avatar
Distrb
Regular Poster
 
Posts: 4756
Joined: Thu Jan 23, 2003 4:23 pm
Location: Wellington

Postby MrOizo » Thu Sep 07, 2006 2:20 pm

2LTR Rona wrote:
MrOizo wrote:oh yeah - and if you go through a stop sign. then stop!


if you have gone through a stop sign isn't a little bit too late :P (i know what you were meaning)


ok my bad!

half aslee... when you come up to a stop sign... make sure you actually stop :)
User avatar
MrOizo
Toyspeed Legend
 
Posts: 6658
Joined: Thu May 16, 2002 9:26 pm
Location: Onehunga, Auckland

Postby Penny » Thu Sep 07, 2006 2:32 pm

MrOizo wrote:
eritate wrote:
i hate going slow in road works when everyone else wants to go fast :( i feel as though im letting everyone down LOL


If you like speeding through road works then dont complain when they have to rip the seal up again and again. the main point about going slow when new chipseal is down is for it to be bedded in.



...not to mention what the loose stones can do to your paint!
User avatar
Penny
Toyspeed Member
 
Posts: 659
Joined: Fri Jun 20, 2003 10:36 am
Location: Palmerston North

Next

Return to General Car Discussion

Who is online

Users browsing this forum: Google [Bot] and 44 guests