20v power/torque output

[Dragger_Dan]

The 16 valve had just a little bit more help.

So what counts as 'just a little bit more help' for RedMist?

[RedMist]

TWR headwork.
Arias forged pistons
Redtop smallport rods and crank.
Kelford L7 cams
Kelford shim under bucket solution
quad throttle bodies
Lynn Rodgers 4-2-1 headers
Wasted spark
Link LEM4

[sergei]

I had 2 engines in it, preface lift/facelift intake manifolds, 2 different computers (later Mines), and funny output on the dyno did not change much. A lot changed in between (Completely different engine, different intake manifold, different exhaust setup, even run black top cams), not much gain from stock...

[CEvans]

i would have thought the blacktop would have been a little more powerful
my old wheels 2002 gsxr 750 was putting out 138hp atw.so my bzr got a little way to go then.

[UltraSonic2]

to be honest i think toyota over rates it's 20V and GTZ they never put out the numbers there ment too. and you can see this on the 1/4 mile too.
my GTZ with a pulley made 86kw at the wheels

[Bling]

my GTZ with a pulley made 86kw at the wheels

local GTZ down here put out 107kw/atw before he got a pulley kit (ae101)

[RedMist]

to be honest i think toyota over rates it's 20V and GTZ they never put out the numbers there ment too. and you can see this on the 1/4 mile too.
my GTZ with a pulley made 86kw at the wheels

Thats because Toyota quote flywheel HP without ancillaries. Substancially more than the likes of you and I will see at the hub.

[RomanV]

Do they still do this?

I heard they started testing them 'properly' at some stage.