4age head bolts

[drftnmaz]

i need some new head bolts for my turbo 5k.. and talking to some1 they said i should use 4age ones, they also thought that the 16v ones used two different types of bolt short on one side and long on the other, is this true?

what is the torque for the factory bolts? i can only find the tighten to 30ft then turn 90 and then another 90?

someone else i was talking to reconed the 20V heads use all the same bolts and they are the ones im after, can aomeone confirm?

and if you do have some old bolts lying around and could measure them and stick up the specs that would be mint. (maybe even a pic?)

[Mr Revhead]

yes 16v are shorter on one side

20v ones the same length

[drftnmaz]

cool, so whos got a old bolt lying round they could quickly measure?

does anyone stock the arp bolts for a 20V? i checked with segidins and they only had 16V listings

[Mr Revhead]

cant get ARP head bolts for the 20v

[AceSniper]

you can... sorta... buy two sets of the 16v kits and only use the long ones

[Mr Revhead]

have you tried it?

i sent a 20v head bolt to ARP and they couldnt match any up...

[AceSniper]

nar I dont know for a fact so yea ignore that comment unless your sure,

what about stock ones check out how long 16v one is against the 20v one...

[drftnmaz]

i measured my stock one today it had a 10x1.25 thread and was just under 4 1/2" long. can use a 5" if its a stud rather than a bolt. anyone know where to get something along those lines?

2 16V arp sets is gonna be pricey as.... i will get proper arp studs but the next shipment isnt for a while so i need something to use for trackday next week

[AceSniper]

bolt it down, tig the bolts to the head, then do a tidy weld around the head/block