Ok, so have an EDIS setup for my 4K-E to do wasted spark with the MS-II. This means I only need a 36-1 trigger wheel and no dizzy, however K series dizzy drives the oil pump. Has anyone done a cut down dizzy to retain the drive? Any pics or tips appreciated, don't have a spare dizzy yet to play with. I assuming cutting it down will be relatively easy, then just need to cap it and ensure the shaft can't move up and down.
Also, anyone attached a trigger wheel to the back of a K series crank pulley?
Callum
Wasted Spark on a K Series - Oil Pump Drive Replacement?
Moderator: The Mod Squad
4 posts
• Page 1 of 1
Wasted Spark on a K Series - Oil Pump Drive Replacement?
by wde_bdy » Thu Oct 20, 2011 12:22 pm
-
wde_bdy - Toyspeed Member
- Posts: 2704
- Joined: Wed Oct 23, 2002 11:43 pm
- Location: Gisborne
by strx7 » Thu Oct 20, 2011 2:03 pm
put the guts off a 3SGE/3SGE/2JZ/2TZ etc etc dizzy ontt/into the K series dizzy
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by Dell'Orto » Thu Oct 20, 2011 6:22 pm
Would just get an alloy cap made up like the 20v conversion ones
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
-
Dell'Orto - ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 5:07 am
- Location: Straight out the ghetto, Lower Hutt
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 14 guests