Hey,
So after fixing the speedo sensor fault with the soldering in the dash I cleared the fault codes. Then I rechecked the check engine light. The 42 speedo fault was gone but the 21 oxy sensor fault was still there even though I had not driven the car since clearing the codes.
The car runs fine and the check engine light doesn't come on while driving. Fault only comes up when I bridge the diagnostic terminals.
Last time an oxy sensor failed on me the car went into a super gutless mode. This time the car runs fine. Any ideas on what might be the problem?
Also my airbag doesn't come on when I turn the ignition on but have checked and the bulb is fine... just doesn't seem to perform a self check. Is this possible that a plug has been dislodged from a module or is the self check integrated into the ECU or something???
TIA
Andy