My Supra's making a wicked noise, almost like a grinding noise when i turn the wheel full lock. Checked the tie rods and steering arms and they're sweet. Filled it up with p/s fluid and it was still groaning.
Been sitting up on jacks untill now, turns out everything wasn't fixed since the f**ker stole it.
Could this be my powersteering pump or something along those lines? As i can't see any physical damage in regards to the steering.
Cars a Ga70 Supra.
Wicked Steering Noise.
Moderator: The Mod Squad
4 posts
• Page 1 of 1
by RS13 » Wed May 03, 2006 10:14 pm
Sounds like your pump bearings are shot, chap. Not something you could deliberately do, just wear and tear..
Daily driver: Toyota RunX/Toyota Caldina
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
Ex: 2x AE101, 5x KP60, KP61, EP71, 3x KE70, KE72, AE70, AE82, 2x TE71, AE90, AE92, ST170, plus 11 Hondas, 12 Nissans, 6 Fords, 4 Mazdas, 3 Mitsis, an Isuzu and a Lada!
-
RS13 - Toyspeed Member
- Posts: 3580
- Joined: Tue Oct 07, 2003 9:07 pm
- Location: Christchurch
P/S noise...
by jondee86 » Fri May 05, 2006 6:06 pm
This is a different noise to the noise of the relief valve opening when
the steering hits full lock on either side ?? Like, does it ONLY happen
when the steering hits the end stops ??
Cheers... jondee86
the steering hits full lock on either side ?? Like, does it ONLY happen
when the steering hits the end stops ??
Cheers... jondee86
1984 AE86 Corolla GT Liftback, NZ new... now with GZE
spec small port, twinscrew s/c and water/methanol injection
Watch this space >>> <<<
spec small port, twinscrew s/c and water/methanol injection
Watch this space >>> <<<
-
jondee86 - Toyspeed Member
- Posts: 903
- Joined: Mon Aug 18, 2003 11:08 pm
- Location: Wellington
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 26 guests