When it comes to cars what can you do / have you done.

[Adydas]

Simple intrest poll, Please be honest as votes will only lie to your self.

Any bickering or negative comments will result in a lock by me and i am intrested to know the stats from this.

So please IF you REALLY have to comment keep it clean.

I can only assume your vote means you can also do the stuff below to.

I assume mates gave a hand as no one can carry a gearbox alone unless

[FrEsH]

standard installer i'd say as i haven't tried to chagne a clutch/engine etc yet...haven't had to

[2LTR Rona]

Engine swapper / Gearbox changer / Clutch fitter I would say moving more towards the other two i.e. currently rebuilding my Capri from the ground up (with help here and there) and will then move on to the KE25 with the engine swap

[Adydas]

we all are a talaented bunch of buggers arnt we :p

[MINTFX]

Standard installer here, but I have replaced my own clutch, fuel pump and other crap. I could probly do an engine swap with the right tools and directions. I have pulled a motor apart aswell, didnt put it back together though as it had a huge hole in the side of the block

[Emperor]

I'm inbetween Basic and Standard. I can do my own sounds, pod filters, oil changes, etc

Though I do admit I ask for help on most stuff.

[supradave]

When it comes to my car im not to bad but give me basically anything else, especially different make im lost. and dont get me started on subaru's lol

[Malcolm]

as far as my own cars go, I know them almost inside out and do almost everything myself (except machine work - since I don't have the right machines, and wheel alignments, because I don't have an alignment rig )

If I was to perhaps have someone throw a 2005 Audi at me or something, I think I'd be fairly lost...

[RomanV]

If I was to perhaps have someone throw a 2005 Audi at me or something, I think I'd be fairly squashed

Corrected!

I can do a few things, but Im definitely not at the same level as someone like Malcom or Vvega... Much respect.

Im getting there though, still learning new things all of the time.

[Dell'Orto]

I can do most things myself...have done engine builds (nothing particularly high tech, 12A 6port would be about the trickiest). Done engine, clutch, gearbox and diff changes.
Only things I can't do are similar to Malcolm...and fabrication, cause I dont have a welder [/b]

[Malcolm]

If I was to perhaps have someone throw a 2005 Audi at me or something, I think it would ricochet off my manly chest and land in a quiverring heap in the corner!

Corrected!

Double-corrected!

[V8MOFO]

I can install I.C.E and change a tyre.

I'm the MAN.

[Santa'sBoostinSleigh]

currently im an installer, but with my racecar im moving towards engine swap!
a few more tools and a bit of guidance and i'll be there!

[Alex B]

On the low side of 'Engine swapper / Gearbox changer / Clutch fitter' if that makes sence.

[vvega]

im a cheque book racer

[3VLTOY]

Done an engine swap and manuel conversion but did have a friend there teaching me as i went.
Brake pads, oil change etc. are a piece of piss to do on my own.
Prefer to buy the parts and do it on my own or have someone showing me how to do new things

[Brick]

done clutch, head gasket, taken engine apart and rebuilt it with guidance, brakes and other minor things

[Boosted_162]

I have no problems putting things where they are designed to go, eg swap a gearbox etc. But when it comes to putting things where they arent designed to go (aka vvega and his 1UZ AW11) i get lost.

[DJ]

Have a guess...

[EVL GSXR]

Have a guess...

I put Basic and Standard..
Own Stereo, Brake Pads, Filters, Oil Changes, Boost Controllers etc etc