Toyspeed.org.nz Message Board

by **AE101Z** » Wed Apr 21, 2004 3:38 pm

just wondering can a 4agze install a boost controller? and the standard boost of ae101 sc

by **Monsterbishi** » Wed Apr 21, 2004 3:41 pm

AE101Z wrote:just wondering can a 4agze install a boost controller? and the standard boost of ae101 sc

Standard boost is around 8psi, and since boost is controlled by the size of the crank pulley, no a controller is not a usefull idea...

by **Banga69** » Wed Apr 21, 2004 4:38 pm

JiNX wrote:
AE101Z wrote:just wondering can a 4agze install a boost controller? and the standard boost of ae101 sc

Standard boost is around 8psi, and since boost is controlled by the size of the crank pulley, no a controller is not a usefull idea...

as kinx had already mentioned you cannot use a boost controller on a s/charger. as boost in run by a belt and a bigger crank pulley. so if u want more boost you'l need a biiger crank pulley.

hope that helps

by **AE101Z** » Thu Apr 22, 2004 2:13 am

i have a oversized pulley buy since i installed it my car is slower after 100km/h than the standard. anyone know why????so i just wondering maybe a boost controller will help

by **Lanius** » Thu Apr 22, 2004 7:40 am

Belt slip? Do you hear a squealing noise at all when you go over 4 or 5000rpm?

by **93Levin4AGZE** » Thu Apr 22, 2004 8:56 am

maybe not enuf oil pressure.
or as Lanius said, check ur belt.
supercharger belt tend to get loose and dont bite well..

by **Banga69** » Thu Apr 22, 2004 11:44 am

how much boost you running?
have you done the ABV?
could be belt slippage.. need some belt grip helps a treat

by **IH8TEC** » Thu Apr 22, 2004 11:58 am

when i first got my bigger crank pulley and took it for a drive, it felt exactly the same to drive, but then i looked at the speedo and was like damn, it actually does make a huge difference, my has got alot more balls up high now, hope you sort it out man, good luck

brendon

by **AE101Z** » Thu Apr 22, 2004 12:28 pm

Lanius wrote:Belt slip? Do you hear a squealing noise at all when you go over 4 or 5000rpm?

i think that is the problem, so do i just need to change another shorter belt??

by **aesc** » Thu Apr 22, 2004 1:10 pm

Na you just need to adjust the tensioner on the belt

by **Banga69** » Thu Apr 22, 2004 1:53 pm

AE101Z wrote:
Lanius wrote:Belt slip? Do you hear a squealing noise at all when you go over 4 or 5000rpm?

i think that is the problem, so do i just need to change another shorter belt??

yea your tentioner on your idler pulley and soem belt grip will help, but dont tighten it too much otherwise you'l snap the belt or cause damage to your idler pulley, water pump and a/c pulleys. juts tighten it like half turn then take i for a spin if not tighten it again.

Toyspeed.org.nz Message Board

boost in 4agze

boost in 4agze

Re: boost in 4agze

Re: boost in 4agze

j

Who is online