Caldina's Throttle Position Sensor plug: need help

[Wolf_Tm250]

Hello,

I mounted Caldina's TB on my ST205, and now I have to remove my 4-pins TPS plug, leave away IDL pin, and connect the 3 remaining wires to the Caldina's 3-pins TPS sensor:

could anyone tell me the correct position of the 3 wires from the upside ?

Thank you !

[Wolf_Tm250]

From the top or bottom, depends on which way it's mounted.

Anyway, most are
brown = earth
next = sw
next = signal
next = 5v feed

Matt

Hi Matt !

I have the wiring diagram of my 4 pins ST205 TPS plug ( E2 - IDL - VTA - VC ), but unfortunately I don't know the position of E2 - VTA - VC wires on the 3 pins Caldina's TPS, so I can't connect my wires.

So what I need is the 3 pins wiring diagram of the Caldina's Throttle position sensor, the diagram you can find on the repair manual.

Thank you, bye