Toyspeed.org.nz Message Board

by **quinny** » Tue Aug 02, 2005 11:22 pm

axles are the same, noticed drivers axle is 2 piece where the 101 is single, but typical toyota it bolted in anyway. gleaming

by **sergei** » Wed Aug 03, 2005 9:27 am

AE101 4age axle is a 2 piece!

by **quinny** » Wed Aug 03, 2005 1:25 pm

sergei wrote:AE101 4age axle is a 2 piece!

Did i say it was 4age before the conversion?
The factory 4AFE i replaced uses a single shaft and my point was that it fit anyway. relax and take deep breaths there is no need to stress out and jump the gun. I am of reasonable education on this subject having done this work previously

by **sergei** » Wed Aug 03, 2005 8:16 pm

sorry, my exlamation mark must of confuse you... I know that 4afe and 16 valve 4age have single piece drive shaft...

by **rallymazda** » Thu Aug 04, 2005 6:27 pm

i think $600 was from auto parts in chch, $900 was at hursts in chch

by **bad20v** » Thu Aug 04, 2005 6:36 pm

rallymazda wrote:i think $600 was from auto parts in chch, $900 was at hursts in chch

lol, might have been my old 6 speed box, the one with the lunched crown & pinion gears and no 2nd or 3rd gears. :lol:

NOTE: Tarmac motorkana + sticky tyres + lsd + tight corners = broken 6speed gearbox and 4 CV joints!!! Ooops!!! :lol:

Toyspeed.org.nz Message Board

Can I easily put a 6speed BZ-R Box on my BZ-G 5speed Levin?

Who is online