Anyone CC'd a Silvertop head?

[85AW20v]

And if you have, did you also work out how much to take off for the domed pistons? I've used a TRD 0.8mm head gasket but the head already had 0.4mm off it as well so I'm wondering what the compression ratio is now. Its also an interference motor now so hopefully I don't break a cambelt

[matt dunn]

And if you have, did you also work out how much to take off for the domed pistons? I've used a TRD 0.8mm head gasket but the head already had 0.4mm off it as well so I'm wondering what the compression ratio is now. Its also an interference motor now so hopefully I don't break a cambelt

I did ages ago when I had my engine apart to work out my comp ratio,
but unfortunatly did not keep the info.
I had dished pistons so that end was easier to work out.

If you find out again let me know too please.

Matt