Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Skimmed head

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Skimmed head

Postby Skidman » Mon Oct 10, 2005 4:14 pm

Hey is there anybody out there that can tell me how much toyota suggests 3SGE gen1 yamaha heads can be skimmed by? (MAX)
Or dose anybody know how much can be taken off without running into valve clearance problems from experience?
Hondas are made for people who dont know better.
Skidman
Toyspeed Member
 
Posts: 89
Joined: Fri Sep 16, 2005 3:04 pm
Location: HAMILTON
Top

Postby TrouserFxGt » Mon Oct 10, 2005 6:19 pm

Most heads have a little machined or cast flat on them that indicates the maximum depth of machining.

Could be something to check for.
Alcohol, The cause of and solution to all lifes problems.
H J Simpson.
TrouserFxGt
Toyspeed Member
 
Posts: 500
Joined: Sat May 25, 2002 3:27 pm
Location: Marton
Top

Postby adikt » Tue Oct 11, 2005 4:31 pm

you wouldnt have to skim it if you didnt take bloody great chunks out of it with the air router :P
User avatar
adikt
Toyspeed Member
 
Posts: 576
Joined: Mon Oct 06, 2003 6:17 pm
Top

Postby Skidman » Tue Oct 11, 2005 7:15 pm

Yea arnt air tools just the best!!
(but remember it was bent before i did that LOL)
Hondas are made for people who dont know better.
Skidman
Toyspeed Member
 
Posts: 89
Joined: Fri Sep 16, 2005 3:04 pm
Location: HAMILTON
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 12 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.020s | 11 Queries | GZIP : On
cron