lack of power to headunit

Phat beats and out-of-luck crooks. Again, read the Disclaimer first.

Moderator: The Mod Squad

lack of power to headunit

Postby SpeedRacer » Tue Jan 24, 2006 7:23 pm

hey, hust hooked up my head unit and there is no power going to it, have checked all the fuses and they are fine. checked it with a multi meter and it gets a very weak signal. had sent it back because I thought it was the head unit that was broken but turns out the head unit is fine

any ideas?
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy

Postby DeeCee » Tue Jan 24, 2006 7:33 pm

are you using the power and ground wire off the factory loom?
move your ground wire to a metal bolt attached to the centre console frame for starters.

You may have to look at runinng a seperate power wire to the headunit to ensure that you have adequate power :)
GT Four Adovansu
"I want to enjoy the powerful and nimble agility behavior."

Project: viewtopic.php?t=60474
Discussion: viewtopic.php?t=60475
User avatar
DeeCee
Toyspeed Member
 
Posts: 2765
Joined: Tue Feb 03, 2004 3:02 pm
Location: Lower Hutt

Postby SpeedRacer » Tue Jan 24, 2006 7:45 pm

was hoping it wouldnt result in that...

yea have already moved the grounding
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy

Postby DeeCee » Tue Jan 24, 2006 7:57 pm

so you checked the fuses in the kick panel and under the bonnet then? I assume yes as you mentioned previously. and i assumed that you checked the voltage on the the power wire when teh unit was disconnected..

so - the best thing to do is run a new power wire. Not hard, just a bit finicky as you'll have to get some 12ga - 14 ga, solder, ring for battery terminal, some heatshink (if you are so inclined) and some bullet connectors or scotchlocks.
GT Four Adovansu
"I want to enjoy the powerful and nimble agility behavior."

Project: viewtopic.php?t=60474
Discussion: viewtopic.php?t=60475
User avatar
DeeCee
Toyspeed Member
 
Posts: 2765
Joined: Tue Feb 03, 2004 3:02 pm
Location: Lower Hutt

Postby SpeedRacer » Tue Jan 24, 2006 8:04 pm

yea cheked when it was disconnected
kickpanel has things like the horn and a/c etc.? if so yea checked that

how thick is 12- 14ga? in terms of amp cable or speaker wire. mite have some lying around
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy

Postby DeeCee » Tue Jan 24, 2006 8:09 pm

did you check the fuses under the bonnet?
i would advise to get some decent coloured power wire - you get a mechanic or auto electrician under there and he'll go WTF??

here is a chart with the measurements of the wire.
http://www.powerstream.com/Wire_Size.htm

note that for a headunit pulling approx 20amps then you'll want 10guage wire or so.. 12 isn't bad, but its not the best either - i've got 10ga in the car at the mo :)
GT Four Adovansu
"I want to enjoy the powerful and nimble agility behavior."

Project: viewtopic.php?t=60474
Discussion: viewtopic.php?t=60475
User avatar
DeeCee
Toyspeed Member
 
Posts: 2765
Joined: Tue Feb 03, 2004 3:02 pm
Location: Lower Hutt

Postby SpeedRacer » Tue Jan 24, 2006 8:34 pm

ok... hav done some temporary re-wiring....

have a new wirew that goes from positive terminal on battery to constant on headunit, and another that goes from the remote wire where the amp was. the readings were fine, until i turned the key on then they went weak like the factory wires.
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy

Postby Alex B » Tue Jan 24, 2006 9:57 pm

Whats your earth like?
User avatar
Alex B
Toyspeed Member
 
Posts: 6539
Joined: Thu Nov 25, 2004 1:39 am
Location: London

Postby SpeedRacer » Tue Jan 24, 2006 10:28 pm

goes to chassis
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy

Postby Alex B » Tue Jan 24, 2006 10:34 pm

free of paint etc?? sounds a lil weird.
User avatar
Alex B
Toyspeed Member
 
Posts: 6539
Joined: Thu Nov 25, 2004 1:39 am
Location: London

Postby SpeedRacer » Tue Jan 24, 2006 10:38 pm

yeap its on bare metal, guna send the HU back, cant be f'd wasting time on it
Sinister Sleeper 35
User avatar
SpeedRacer
Toyspeed Member
 
Posts: 407
Joined: Tue Apr 12, 2005 10:30 am
Location: Palmy


Return to Car Audio / Security

Who is online

Users browsing this forum: No registered users and 12 guests