Well. My current dash has some issues (wiring issues on the water temp, tacho doesn't work properly above 6500RPM, speedo sometimes plays up, fuel gauge is oddly inaccurate) and I have some gauges that I want to install also. So I was thinking that since I'm reconditioning an engine to go into the car, and onto that engine I will fit the senders for some aftermarket guages (oil pressure, water temp, oil temp, fuel/air) I would look into replacing the whole instrument cluster.
The engine is a blue top 4AGE. But I want to reuse the dash when I build a fresh high rpm 4AGE.
The car is my street car/weekend racer.
I will have these gauges:
Fuel level
Water temp, Oil Temp, Oil Presure, Fuel/air ratio (4in1 guage)
Tacho (10,000rpm?)
Speedo (240kph?)
and wire up leds to indicate:
Turn signal
High beam on
Handbrake/brake fluid level
Are there any "must haves" that I've forgotten?
Because I already have this guage I'll probably also put this on (assuming there's room) Voltmeter, In/out temperature, Clock (4in1 gauge)
And I'll probably put on LEDs showing
Radiator fan operation
Shift light LED (possibly moving bar type)
EWP operation (moving bar type)
Any other useful things I should look at?
Does anyone have a template of the original instrument cluster that I can copy? I'd like to start getting things together before I pull the dash apart.