Whats the rev limiter on a AE101 4agze ?

[beeker]

I be dammed if my google skills can find it.

exact figure please.

[Bazda]

7500

[aesc]

Full redline is 7500 but I thought rev limiter was around 7800. I have accidentally revved mine past 8000 on a few occasions missing hooking 2nd gear

[Rick]

I have accidentally revved mine past 8000 on a few occasions missing hooking 2nd gear

How did you do that??? did you remove the factory rev cut, or are you running aftermarket ecu?

[EVLGTZ]

yeah i thought was 7800rpm as well.

Lifted mine to 8400rpm and still holding together!

[craigt]

Mine has revved past 8000 on one or two accidental occasions. Still factory ECU, dont think its been tweeked. Has a speed limiter at approx 200kph which isnt very difficult to hit at all

[Bazda]

my mate said his ae101 hit 8000 just reving it out through the gears i was like wtf.
cos on the dyno it cut at 7500

[aesc]

Yeah under load id say it would cut earlier, when I revved to 8ish K it wasnt really under load

And yeah ditto to what craigt said - mines got stock ecu

[bluemaumau]

is this the same for the ae92 afm?

[evil_si]

im sure both my ae92 gtz and ae101 gtz would got to 7800.
the ae92 had no speed cut,

[Bazda]

my ae92 gtz turbo cut at 7500, hit that at least 5-10 times a day, it was impossible not to

[matt dunn]

I think you will all find that at 7000 rpm onwards you will be really surprised how far out a standard or even aftermarket tacho will be,
some we've seen have been up to 600rpm out, usually on the high side.

[IH8TEC]

yeah mine always hits at 7500-7600rpm,

evlgtz, how much boost you run it on at 8400rpm? and did you find it beneficial to raise it to that?

[FLAWLES]

yea mine on my ae101 gtz is between 7500 and 7800

but how do you go about lifting the rev limiter? i am running a aftermarket piggy back comp?

[mr pad]

my ae92 gtz turbo cut at 7500, hit that at least 5-10 times a day, it was impossible not to

good man. one of my fav sounds in the world... dirty rev cut on a rb series motor = gazzim.