Hope you've asked this on MMC, there will definately have been one or two guys who've had it done
Off the top of my head, parts alone are around $1100 retail for bearings, gaskets, rings etc etc. Depending on much machine work needs to be done is going to really effect the total cost...a simple hone is gonna be much cheaper than having to bore it 20 thou over.
Also depends if its just gonna be a standard rebuild or if you're gonna take the opportunity to throw in some fun bits.
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!Quint wrote:Not just cock, large cock.