garr

[mupp3t]

got my front left panel painted and rust free - however panel beater mounted it a bit too far back and now it has clipped the door and gotten all mashed and paint is now chipping off. Now have to go to another panel beater to fix that

took the car to mechanics to replace my universal joint - two weeks later joint just drops out about 20km from Wanaka.

as a result of the above, my driveshaft needed balancing urgenty, went to get that done but it would seem they welded a bit tooo close to the car as the passenger side windows are covered in little bits of metal.


fools

[JT]

Gutted!

Take the car back to the original panel beater and get them to fix it. It was their mistake so you shouldn't have to pay to set it right.

Did you get the uni joint sorted? Make them pay for a new window too.

Let us know how you get on, everyone makes mistakes but a good company will go out of their way to make sure you got the job completed for the original price. Always worth warning others if this aint the case.

[Dunny]

Tell us where you went to get that stuff done - so I can make a point of not going there