Toyspeed.org.nz Message Board

Toyota Club of New Zealand Message Board

Skip to content

Wearing in clutch

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

Post a reply

Wearing in clutch

Postby tomo1985 » Mon Jun 26, 2006 11:11 pm

I am replacing my clutch tomorrow and have never done this before. I have one question should I drive easy for say 500kays to let it break in or is there no need?


You opinions please
tomo1985
Toyspeed Member
 
Posts: 206
Joined: Thu Aug 25, 2005 12:12 pm
Location: CHCH
Top

Postby Punter » Tue Jun 27, 2006 9:30 am

Thats how I did mine and i've had no trouble, it was a standard blacktop clutch.
User avatar
Punter
Toyspeed Member
 
Posts: 809
Joined: Fri Jun 24, 2005 2:02 pm
Location: Akl CBD
Top

Postby pc » Tue Jun 27, 2006 10:35 am

Get the fly wheel surfaced at the same time, drive it normally.
red car
1/4 mile - 14.683s @ 91.83mph
Manfield - 1:24s
Taupo - Track1 1:53s (road tyres) - Track2 1:22s - Track3 48s (with esses) - Track4 1:58s
User avatar
pc
Toyspeed Member
 
Posts: 1749
Joined: Fri May 07, 2004 3:10 pm
Location: Upper Hutt Yo!
Top

Postby tomo1985 » Tue Jun 27, 2006 12:07 pm

Im sure it will all be sweet, its going to be so much nicer to drive
tomo1985
Toyspeed Member
 
Posts: 206
Joined: Thu Aug 25, 2005 12:12 pm
Location: CHCH
Top

Postby HELBND » Tue Jun 27, 2006 12:24 pm

just dont drop or ride the clutch heavily for the first 100kms or so

especially if your clutch uses a non organic compound, as glazing on those is permanent :wink:
User avatar
HELBND
Toyspeed Member
 
Posts: 1578
Joined: Tue Feb 15, 2005 2:37 pm
Location: North Shore
Top
Post a reply

Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 4 guests

Powered by phpBB® Forum Software © phpBB Group
Time : 0.018s | 10 Queries | GZIP : On