Toyspeed.org.nz Message Board

by **NA Drifter** » Wed Jun 28, 2006 7:15 pm

By chance anyone know what the interchangeable injectors for 4age 16v (small port) motor? They are factory 235cc (2 Ohm=High Ohm?) and top feed.

I'm looking at something that's around 295cc and top feed with 2 Ohm.

Nissan CA18? or SR20 have the same injector??? or maybe 3SGE?? what are the spec etc??

thanks

Keith

by **slighty_sykotic** » Wed Jun 28, 2006 8:38 pm

3sge are side feed (=20v).

2ohm is low impedance....not high.

--Sykotic

by **matt dunn** » Wed Jun 28, 2006 9:05 pm

and the smallport are 295cc anyway.

matt

by **Jebus** » Wed Jun 28, 2006 9:07 pm

Theyre 235cc dude, 20V are 295cc but are side feed.

by **QikStarlie** » Wed Jun 28, 2006 10:47 pm

4efte is what your after. 295 high imp. smallport are high imp. probably 13ohms or so

AW11 Track Toy · by **Caveman** » Thu Jun 29, 2006 12:51 pm

smallport are 13 ohms. they are rated at 235cc but thats at 3bar. Most toyota injectors run at and are rated at 2.5bar.

by **atmosports** » Thu Jun 29, 2006 7:14 pm

Used starlet(295cc), Toyota 7mge/mgte(430cc) in various 4AGE 16V, also have used various Mitsi like VR4/Cyborg/Evo etc can't remember make models & flow. What injector you go for depnds on your application & what power your after.

by **NA Drifter** » Fri Jun 30, 2006 12:13 am

cool, thanks alot.. so 4efte then? I'm trying to "replicate" a 16v motor with blacktop ecu running as close as std 20v blacktop. ... if u get what i mean..

Toyspeed.org.nz Message Board

Injector spec

Injector spec

Who is online