Silicone Request

[MrOizo]

I rememebr seeing some where that there was a configuration of silicone piping that lookled something like this:



Is there anywhere (pref. in AKL) that can supply something like this?

Would be needing along the lines of 2" on the big ends and then approx 3/4" for the smaller outlet.

And FYI - looking at something like this for between the turbo and IC on a ST165 rather than the metal ones that i have seen used - very hard to get in/out as well

[sergei]

tried samco?

[evil_si]

alert motor sport, garador place

[sergei]

is it for this?

[Pies]

offtopic... but adrian... how long did you spend drawing that pic? i love the use of gradients. you really put some effort into it didnt you!

**** four gold stars for you!!

[MrOizo]

is it for this?

Thats exactly it@!

Where is this samco place? wouldnt mind sorting this out while the top of the engine is in bits.

Evil Si - will try them also..


Pies - didnt really take all that long... thought i should use gradients to give it (well try) a 3rd dimension

Took all of 1-2 mins

[evil_si]

ahh well alert engineering are the nz distributor for samco.

[MrOizo]

ahh well alert engineering are the nz distributor for samco.

Sweet... will be looking them up

For peoples info:

http://www.merlinmotorsport.com/index.p ... =1742_2021