How do i set up 7mge timing?

[UTERUS]

The 7mge in my mark2 had a blown headgasket so i have replaced it and torqued it down.

The problem i have now is aligning the cambelt and distributor up.

The crank pulley has a mark on it and the mark is pointing at 10 (degrees before/after tdc?)

The marks on the cams are pointing straight up to their (tdc?) marks aswell.

I can't verify that the distributor hasn't been played with while it was out.

The cambelt has lined up in exactly the same place on the cams, i know this because i drew a line on it that lines up with the timing mark on the cams.


What should i do next?



Cheers,
Simon

[Jason T]

http://www.cygnusx1.net/Supra/TechTips/setting_timing.aspx

[Toymad]

Try this page for the mechanical timing (as well as a few past it):

http://www.cygnusx1.net/Supra/Library/T ... EM&Page=22

Then for the distributor timing, go here:

http://www.cygnusx1.net/Supra/Library/T ... IG&Page=19

You may want to bookmark the site for future reference.

[UTERUS]

You guys are legends