Can someone identify this turbo? Supra?

[VRFOE]

Can someone identify this turbo? Supra?

Hi there,

I have recently aquired a "hybrid" engine. It is a 4G93 (1.8L Mitsubishi Lancer GSR) with a custom manifold and turbo on it. I am trying to figure out exactly what turbo it is as I think it will need a rebuild or replacement as it is blowing smoke.

Person who built the engine reckons the turbo is off a Supra but can't remember which model. And someone has stated perhaps it is a CT-26 turbo?





Inlet gasket which is the SAME as a T3


If anyone has any information or suggestions please let me know!

Thanks

[vvega]

not a ct2# turbo
oil fedd and return are on the same flange
and your oil feed looks like its on the top

could be a ht18 with a skyline ex housing and a to4e front cover
but then the wastegate is wrong cause there integal with the downpipe

id go for a td05/6 with a 20g compressor for my guess

whats it go like ?

[VRFOE]

Is this correct?

Doesnt' look like a CT to me, but it's tough to see while it's on the car. It looks more like a generic T3 housing than a CT...again, hard to tell. I was looking for the "V" band clamps that hold the housings on a CT and can't seem to see them.

All turbos can be clocked to face the outlets as needed. To look at the pics again, even the wastegate valve is on the wrong side for a CT, and is connected differently. I would again lean to the t3, or a t3/t4 hybrid turbo.

[vvega]

well he raises a good point it is facing teh wrong way
and as fair as i know all garrets face teh same way too

so were back to ...soem sort of td## series turbo
i.e vr4 evo etc

[VRFOE]

well he raises a good point it is facing teh wrong way
and as fair as i know all garrets face teh same way too

so were back to ...soem sort of td## series turbo
i.e vr4 evo etc

Definately not standard Mitsubishi.

Someone suggested a Skyline turbo of some sort? As they are factory T3 flanged...

[vvega]

how do you know its a t3 flange
....

[VRFOE]

how do you know its a t3 flange
....

Because I put a T3 gasket on it and it fit perfectly...

[vvega]

did you tri a t25