opinions on toasted clutch/pressure plate (with pics)

[Bazda]

ok hang on here lol

If you live in auckland you can take it to this place your self, saves me from doing it

Plus Plastics
09 273 5162
Unit E/83 Springs Road
East Tamaki

ask for Luke

[bluemaumau]

oh ok thought that you had to ask the dude, sweet ill be in there.

cheers

[IH8TEC]

jeremy, just have a drive of my car on your way through over new years, it's not as bad as everyone makes them out to be.

might have to turn the boost down for you though

[flygt4]

hahaha turn the boost down my ass
i bet it doesnt torque steer anywhere near as much as mine

man ive got an intimidating list of parts to replace
barry will your guy be able to mould the mount correctly even if the rubbers are completely separated from it ?

previous owner was a mechanic so i picked it up with a engine thats proved itself and all the basic setup there, just needed to tidy it up. this is the first time ive had to remove the box so far, and when i put it back together im going to do all the tricks that make it a lot easier next time, like slotting the corssmember, and welding nuts in the right places etc.

[Bazda]

the guy will burn out all the rubber in that case and place the inner metal part in seperate in the centre.