Fact or fiction??
Moderator: The Mod Squad
4 posts
• Page 1 of 1
Fact or fiction??
by TOYROTA » Wed Jan 31, 2007 3:17 pm
i read some where that if you slightly overbore a k motor you can fit 16v 4age piston into it. can anyone confirm this and wout there be any advantage apart from strength.
Curre3nt rides-
1982 starlet kp61 4 door (in panel shop getting bare metal resto)
1980 tt132 corona wagon 3t t40 (daily doomsday machine)
1982 starlet kp61 4 door (in panel shop getting bare metal resto)
1980 tt132 corona wagon 3t t40 (daily doomsday machine)
-
TOYROTA - Toyspeed Member
- Posts: 347
- Joined: Thu Jul 17, 2003 8:35 pm
- Location: HAMILTON
by Punter » Wed Jan 31, 2007 4:52 pm
4age bore = 81mm
K series bore = 75mm
Common sense would say no.
But I believe 1ggze pistons are the 75mm bore and are apparently the same construction as 4agze pistons. So thats probably what your thinking of.
K series bore = 75mm
Common sense would say no.
But I believe 1ggze pistons are the 75mm bore and are apparently the same construction as 4agze pistons. So thats probably what your thinking of.
-
Punter - Toyspeed Member
- Posts: 809
- Joined: Fri Jun 24, 2005 2:02 pm
- Location: Akl CBD
by Dell'Orto » Wed Jan 31, 2007 5:17 pm
Do 1G pistons have valve cut outs in them? Unless you were going to turbo it, I'd say the valve cutouts would be more of a hinderance.
1988 KE70 Wagon - Slowly rusting
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
1990 NA6 MX-5 - because reasons
2018 Ranger - Because workcar
1997 FD3S RX-7 Type R - all brap, all the time
OMG so shiny!
Quint wrote:Not just cock, large cock.
-
Dell'Orto - ** Moderator **
- Posts: 17494
- Joined: Tue Jul 08, 2003 5:07 am
- Location: Straight out the ghetto, Lower Hutt
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests