gaskets
Moderator: The Mod Squad
3 posts
• Page 1 of 1
gaskets
by Mike- » Sun Feb 18, 2007 8:52 pm
Im after some gaskets for the supercharger piping and went to repco, they didnt have any, so the guy rang toyota and they said they didnt have them either and they had to be cut from gasket paper, is it ok to use some sort of gasket sealant? as i already have some
- Mike-
- Toyspeed Member
- Posts: 890
- Joined: Sat Sep 18, 2004 3:38 pm
- Location: auckland
by AE82 FXGT » Sun Feb 18, 2007 10:00 pm
Depends on what type of sealant.
Gasket paper isn't that expensive, and not hard to make gaskets from.
Just trace around the part or use a ball pein hammer.
Gasket paper isn't that expensive, and not hard to make gaskets from.
Just trace around the part or use a ball pein hammer.
Previous: '85 AE82 FXGT, '92 AE101 GTZ, '92 AE101 GT-APEX, '04 SE3P RX8, '05 Mazda 6 MPS, '97 NA8C MX5, '03 GSX250, '08 ZX6R, '13 GROM
Current: '07 GRE156 BLADE MASTER G
Current: '07 GRE156 BLADE MASTER G
-
AE82 FXGT - Toyspeed Member
- Posts: 1594
- Joined: Thu Nov 04, 2004 1:51 pm
- Location: Lower hutt
by CAMB01 » Mon Feb 19, 2007 7:48 am
Dont use sealant on a forced induction motor. make gaskets, thats what i did with mine.
1993 Mitsubishi EVO 1 Racecar
1998 Mitsubishi Mirage ZR Asti Mivec (Daily Whip)
1989 AE91 FX-ZS (Previous)
1994 AE101 Levin 20v (previous)
1992 EE90 Corolla Sedan (previous)
1986 AE82 FX-GT Corolla (previous)
1989 AE92 FX-GTZ Supercharged (previous)
1992 EE90 Corolla Hatchback (previous)
Custom Works Automotive
http://www.HCCC.org.nz
1998 Mitsubishi Mirage ZR Asti Mivec (Daily Whip)
1989 AE91 FX-ZS (Previous)
1994 AE101 Levin 20v (previous)
1992 EE90 Corolla Sedan (previous)
1986 AE82 FX-GT Corolla (previous)
1989 AE92 FX-GTZ Supercharged (previous)
1992 EE90 Corolla Hatchback (previous)
Custom Works Automotive
http://www.HCCC.org.nz
-
CAMB01 - Toyspeed Member
- Posts: 1440
- Joined: Fri Jan 17, 2003 11:33 pm
- Location: Wellyz
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests