Toyspeed.org.nz Message Board

Toyspeed Profile - MrOizo · by **MrOizo** » Wed May 28, 2003 1:10 pm

As the topic lads.... and ladies

Teh Mingi · by **Roush** » Wed May 28, 2003 1:26 pm

Im keeping the faith

YUSSSSS!!

by **MrBob** » Wed May 28, 2003 1:54 pm

I'll have to go maybe....im sure the engine is tough enough to handle the turbo, but im not sure if its tough enough to handle your fat right foot constantly punishing the accelerator :lol:

Is anyone taking bets on the longevity of you motor ?

by **MRT1TRD** » Sat May 31, 2003 10:40 pm

Well im gessin it didint survive since i found you at pik-a-part buyin a new engine.

by **hipsi** » Sun Jun 08, 2003 4:03 pm

is it still going what mods have you done?
i have a 4agte also its done 1800 ks soo far and all ive busted is a water pump and thermostate gasket it goes fucin hard on 12psi.
let me know!!

Toyspeed Profile - MrOizo · by **MrOizo** » Mon Jun 09, 2003 1:00 am

lol hipsi, a more apropriate question would have been "what havent i done" :oops:

I went up the road for about 10 mins and i managed to blow the bluetop as i was running stock fuel, ECU, timing, and no cooler... bad idea...

but yeah... went damn hard on 10psi

by **hipsi** » Mon Jun 09, 2003 11:24 pm

i ran std timing for about 800ks then had it retarded 9 degrees.
did you run it in? decompress it?
i didnt give mine 10psi untill i hit 1500 ks to be safe im now on 15psi and its kicking arse so many ppl laugh wheni pull up beside them but they aint laughing 30sec later haha!
i cant wait to go down the quaters and see what its pulling.
i have stock ecu also but it seems to have re mapped itself to boost so thats all good and i have an apexi air fuel controller to save it from being soo damn rich

Toyspeed.org.nz Message Board

Time for a real poll - Will my 4AGTE survive?

Will the mighty 4AG(T)E survive?

Time for a real poll - Will my 4AGTE survive?

going?

lol

Who is online