new apexi neo

General discussions on all non technical car related topics

Moderator: The Mod Squad

new apexi neo

Postby frost » Fri Mar 23, 2007 12:22 am

anyone played with one of these yet?
are they as good as they sound? im thinking of getting one.
also did anyone find a solution to the retarding of the timing by the factory ecu problem (even with the earlier safc & safc2)
frost
Toyspeed Member
 
Posts: 1705
Joined: Mon Aug 08, 2005 11:19 pm

Postby RH9 » Fri Mar 23, 2007 11:20 am

Work well on 25t Skylines, seen a car go from 160kws to 210kws just by tuning the fuel via the Neo.

Good unit
User avatar
RH9
Toyspeed Member
 
Posts: 160
Joined: Tue Aug 16, 2005 4:57 pm

Postby thaphatty » Fri Mar 23, 2007 1:22 pm

wtf. are you serious?

dyno sheet please
Adamal wrote:Harro, this your captain speaking. Wercome to fright free nine five to Werrington
User avatar
thaphatty
Toyspeed Member
 
Posts: 1172
Joined: Thu May 22, 2003 7:55 pm
Location: Hamilton

Postby chch34 » Fri Mar 23, 2007 10:33 pm

RH9 wrote:Work well on 25t Skylines, seen a car go from 160kws to 210kws just by tuning the fuel via the Neo.

Good unit


must have been running Faaaaarken rich to cost 50kw!!! :lol: :lol:
Dori Clothing Co.
www.teamSclub.co.nz
chch34
Toyspeed Member
 
Posts: 300
Joined: Wed Mar 02, 2005 11:19 pm
Location: Hamilton

Postby vvega » Sat Mar 24, 2007 12:00 am

some cars are tuned quite conservative from factory
50kw is not a unheard of gain.. but it woudl have taken a decent tuner to make that reliable :D
vvega
 

Postby frost » Sun Mar 25, 2007 4:29 am

ha i was thinking of maybe getting 5whp, but if could pull those numbers I'd be really happy. i just put the order in for the neo. i'll post dyno when its installed and tuned.

but on the other topic i remember someone saying you can run with out a oxy sensor and have no side effects. if this true?

if it is then i was thinking don't run it and the factory ECU wont know its running different then factory fuel maps. and in turn not retard the timing as is world do when it senses an off the norm reading. does this sound correct or does the ecu just go into limp mode if the oxy sensor is not plugged in?
frost
Toyspeed Member
 
Posts: 1705
Joined: Mon Aug 08, 2005 11:19 pm

Postby fivebob » Sun Mar 25, 2007 5:10 am

frost wrote:if it is then i was thinking don't run it and the factory ECU wont know its running different then factory fuel maps. and in turn not retard the timing as is world do when it senses an off the norm reading. does this sound correct or does the ecu just go into limp mode if the oxy sensor is not plugged in?

No, it doesn't work like that. The SAFC/Neo etc fool the computer into thinking that it's flowing less air than it is by altering the MAP/MAF signal. Less Flow = Less Load = More Timing because the ECU thinks it's in a different part of the map.

Quite often a large amount of these impressive gains are due to the dangerously advanced ignition, not the leaner fuel mix. Unless you have some way of altering the timing then these devices are a sure way to damage your engine. :evil:
User avatar
fivebob
Toyspeed Member
 
Posts: 3879
Joined: Fri May 02, 2003 5:12 pm
Location: Tauranga

Postby Adydas » Sun Mar 25, 2007 11:45 am

Ive noticed when shopping around there are alot of ECUs out there so cheap, its just can tuners tune them...

Look at the ones Driven Performance is advertising under a grand was it? or just over for a full replacment ECU, Not bad when a Neos what $300-600 and has no were near the full capabilities..
User avatar
Adydas
** Moderator **
 
Posts: 5059
Joined: Mon Jun 10, 2002 4:00 pm
Location: Auckland nz

Postby chch34 » Sun Mar 25, 2007 1:56 pm

yea ya may as well spend $1000 and get a LEM or PFC and get that tuned. then ya might see 50kw gains.
Dori Clothing Co.
www.teamSclub.co.nz
chch34
Toyspeed Member
 
Posts: 300
Joined: Wed Mar 02, 2005 11:19 pm
Location: Hamilton

Postby frost » Sun Mar 25, 2007 9:55 pm

na i got the neo really cheap. so thats why i got it.
im not ready for full replacement yet. im still getting use to the car and engine. im not going for full out power or anything, I'll just see what the chassis can do and work my way up to bigger and better mods later on.

fivebob: oh ok i see. thanks for that, i had it totally wrong way round in my mind.
frost
Toyspeed Member
 
Posts: 1705
Joined: Mon Aug 08, 2005 11:19 pm


Return to General Car Discussion

Who is online

Users browsing this forum: Bing [Bot], Majestic-12 [Bot] and 19 guests