4age parts interchangeability

[3T-Rona]

il disconect my accelerator cable just to be super duper sure what if i disconnect the tps????

[matt dunn]

if it's not set right neither of those will help.

[l1ttle_d3vil]

i know that the diagnostic wire is the red w white, no.17 in the 18p plug (via club4ag) but have had no luck with earthing it out

is it a genuine rwd ecu, with the pinouts as shown here:
http://www.club4ag.com/faq%20and%20tech ... 04A-GE.htm

or is it a fwd ecu and loom? as shown here?
http://www.club4ag.com/faq%20and%20tech ... 088-89.htm

take the cover off ur ecu and check which of these pin-outs match up with ur ecu

[3T-Rona]

looks to be fwd yo, how do i reset the tps then...... probabl should search aye

[l1ttle_d3vil]

get a multimeter and check the faq, theres the specs in there for the tps. you just measure the resistance between each terminal and make sure its within spec, if not you adjust it.

[3T-Rona]

i tried adjusting the tps and its no good, specs dnt match up, like between the blue and the red wire it should be <2.3ohms and it wnt go over 1.5ish, if i move it around itll go up to 1.5ish then drop dwn to nothing or ifinity...... faulty tps?

[3T-Rona]

.........

[3T-Rona]

.........