1JZGTE waterpump

[dirty rb]

Prob been covered before but....
I have a 1jzgte from a jzx90 running the waterpump with the hydraulic fan. Which pump is best to use as I dont want the hydo fan.
Which pulley will I need. Have a pulley from a 2JZGE but dont know if that will work on anything

Thanks Guys

[spencer]

I just went to repco (only because of discount) and the item they listed was a non hydraulic fan version I had a 1jzge pulley and used that it all worked. Also get the cam belt and tensioner from toyota while your there didn't cost much. Also the other 1jz i had was from a jzz30 soarer it didn't have the hydralic fan. I recommend the supra forums for your 1jz questions theres shit loads on there and most stuffs been covered, only seems to be a handfull on here

[Py7h0n]

If the pully is the 4 bolt type it will work.

Grab the waterpump from toyota (only $120+gst retail )

Part number 16100-49846

If your pully is not a 4 bolt type you will need the following pully (2JZ-GTE)

16371-46020

[postfach]

If the pully is the 4 bolt type it will work.

Grab the waterpump from toyota (only $120+gst retail )

Part number 16100-49846

If your pully is not a 4 bolt type you will need the following pully (2JZ-GTE)

16371-46020

I don't think any of the hydraulic fan type water pumps have the 4 bolt pulley, they're all spline with 1 bolt, also it's not just the 4 bolts that matter, the offset of the pulleys are different. in any case, the part numbers listed above are correct. (i think the 2JZ-GTE has a hydraulic fan though? a typo perhaps? Maybe you mean 2JZ-GE?)


Oh, and hurry up and get your car going, I can probably drive mine again by the end of the week if I stop being lazy and put that plenum on.