Toyspeed.org.nz Message Board

by **JustinSpiderholden** » Sun Sep 23, 2007 10:39 am

Alrighty have got my 3sgte all mounted in the car now, trying to simply the factory water piping and removing factory heater piping as im not going to be running a heater, i have identfied all the water lines except for the water retun from the turbo does that go back into the block ? As i cannot seem to find where the return is from the turbo

Toyspeed Profile - MrOizo · by **MrOizo** » Sun Sep 23, 2007 6:07 pm

Water return from turbo goes back into the top of the radiator with the rest of the hot water.

by **RunningRich** » Sun Sep 23, 2007 9:13 pm

Depending on which generation 3S-GTE you have...

Toyspeed Profile - MrOizo · by **MrOizo** » Sun Sep 23, 2007 9:35 pm

yeah my bad... Gen1 3SGTE is back into top of rad

by **JustinSpiderholden** » Mon Sep 24, 2007 9:20 am

Generation 2, come on guys some one must know, pics would be helpful

by **Phothog** » Mon Sep 24, 2007 10:29 am

JustinSpiderholden wrote:Generation 2, come on guys some one must know, pics would be helpful

from memory, it has been awile since i have seen a Gen 2 motor, the turbo water pipes go back into the heater pipes...

in fact follow this.
http://www.ayrpark.plus.com/epc/mr2epc.html
follow into EPC 1, then engine, then radiator & water outlet.

the bottom picture is the one you are looking for...

91511-60812 is the water pipes for the factory CT26.

Chris.

Toyspeed.org.nz Message Board

3sgte Water Piping

3sgte Water Piping

Who is online