Toyspeed.org.nz Message Board

by **high_lux** » Wed Jan 16, 2008 9:00 pm

hey there im after a stainless small port inlet manifold flange to make up a inlet manifold any one know where you can buy/get them made from?

by **evil_si** » Wed Jan 16, 2008 9:34 pm

north shore plate cutting, best to give them a gasket as a sample as they have hundreds of different inlet flanges on file

by **postfach** » Wed Jan 16, 2008 10:25 pm

they're the guys in volkner place in right? i've had some stuff done there, pretty good guys, reasonably priced, too

by **strx7** » Thu Jan 17, 2008 6:43 am

what thickness?

by **terola** » Thu Jan 17, 2008 7:04 am

to answer his question for him hes after 10mm

by **evil_si** » Thu Jan 17, 2008 8:01 am

yea thats them in volkner place,

Inlet manifold flange...where to buy from?