Toyspeed.org.nz Message Board

by **gleem** » Mon Mar 10, 2008 8:22 pm

i've taken my airbox out and im not too sure what to do with this pipe, do i just leave it hanging there or what, it makes a real annoying sucking noise and when you put your thumb over it it turns the car off >_<
Am i ment to put this in the new intake piping or intercooler piping? Also that plug that goes in to the airbox what should i do with that just leave it dangling there?

cheers!

http://www.youtube.com/watch?v=bi_7wuIdP08

by **99gtt** » Mon Mar 10, 2008 8:44 pm

you need to put a breather tank in there ,same as a catch can with a filter on it . That pipe is your cold start. Just tie the temp sensor up some where or if you want you can plum it in but not necessary.

by **gleem** » Mon Mar 10, 2008 8:54 pm

so i just chuck a breather filter on and ditch the rubber hose?

by **rodstr** » Mon Mar 10, 2008 8:55 pm

idler feed, 15mm breather filter should fix that problem. dont think you need a catch tank as you wont be catching any oil

edit: yes and ditch the hose

by **99gtt** » Mon Mar 10, 2008 8:57 pm

Try it it might work but i think it needs to be contained

by **rodstr** » Mon Mar 10, 2008 9:12 pm

excuse my ignorance but what needs to be contained? :roll:

by **99gtt** » Mon Mar 10, 2008 10:45 pm

as in an enclosure . If you just put a filter on 1, you will have constant hissing noise 2, idle fluctuation

by **rodstr** » Mon Mar 10, 2008 10:50 pm

oh right ok, didnt notice any hissing on my one in cabin, not even that loud at all, only on startup when cold, goes away in a few mins.

by **bubz** » Tue Mar 11, 2008 3:31 am

I have plumbed it into my intake hose and also connected the Temperature sensor.This is how I have mine:

Toyspeed.org.nz Message Board

gtt intake question

gtt intake question

Who is online