by postfach » Wed Nov 21, 2007 5:20 pm
All the cars I've ever taken the rear seat out of have worked like this:
On the bottom, at the front of the part you sit on, on either side, there is a tab thing, pull that (when you see it, it should be fairly obvious which direction to pull, usually down, forward, or both). The seat should pop up at the front, if it doesn't, give it a bit of a tug upwards while pulling the tab. Once both sides are out, you can pull the seat bit forward and out of the car.
Is the seat one of those fold down ones or is it fixed back?
Fixed back type:
Look around the bottom of the back part of the seat, on either side, and in the middle, there are usually bolts holding it on, undo them, and then pull the seat upwards, there are hook things behind it which you need to lift it off before you can pull the seat forward.
Fold down type:
Pull up the knob things that release the catch, so you can fold the seat down, then, fold it down. Look around the bottom corners of the seat, should be a hinge there, unbolt the hinge on both sides, and voila, seat is undone.
Disclaimer: I've never taken the back seat out of an Altezza, this is just how it's been done on all the other cars I've owned/worked on in the past.