Hi all..
Problem: the thermostat housing ony my beams 3sge - sticks out perpendicular (90 degrees) from the block and pointing slightly down. This puts it in the way of a lot of things. (since the engine is no longer in the orginal car)
option 1: Is there a thermostat housing from a another variant of the 3s engine or any toyota that will fit and point forward from the block? If so where can I get one?
option 2: Cut the existing housing and get it welded so it points out the front of the engine
comments please
cheers
aaron
3S Thermostat Housing
Moderator: The Mod Squad
4 posts
• Page 1 of 1
3S Thermostat Housing
by nz_climber » Thu Sep 25, 2008 7:20 pm
- nz_climber
- Toyspeed Member
- Posts: 322
- Joined: Sat Dec 20, 2003 10:29 pm
- Location: Bulls
by strx7 » Thu Sep 25, 2008 10:36 pm
what is the motor originally out of?
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
by Bling » Thu Sep 25, 2008 10:43 pm
Celica RA45 wrote:you can use a gen 3 which points to the front ,same as fwd beams
or the altezza 1 which has a droopy dcik and goes forward then goes 90%from that
moved from a new thread made by Celica RA45
-
Bling - ** Moderator **
- Posts: 15990
- Joined: Mon Dec 22, 2003 9:02 pm
- Location: Quake City
- nz_climber
- Toyspeed Member
- Posts: 322
- Joined: Sat Dec 20, 2003 10:29 pm
- Location: Bulls
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 29 guests