I was having trouble getting my hilux into gear, so i replaced the master and slave cylinder last night. I am still having trouble getting it into gear.
It feels like the clutch is not fully engaged when i manage to get into a gear, as the car slowly moves when my foot is hard down on the clutch.
Have i not bleed the line properly, or have i got the wrong master cylinder?
1990 Hilux Surf
Moderator: The Mod Squad
3 posts
• Page 1 of 1
1990 Hilux Surf
by Nezza » Fri Jun 12, 2009 1:15 pm
- Nezza
- Toyspeed Member
- Posts: 46
- Joined: Mon Mar 17, 2008 6:08 pm
- Location: Dunedin
by FLAWLES » Fri Jun 12, 2009 3:11 pm
pressure plate is naffed ( maybe )
or your cluch plate is ever so slightly warped/twisted which can/may lead your hilux to creep when is 1st gear or a low gear when your foot is ohard on the pedal
or your cluch plate is ever so slightly warped/twisted which can/may lead your hilux to creep when is 1st gear or a low gear when your foot is ohard on the pedal
-
FLAWLES - Toyspeed Member
- Posts: 1856
- Joined: Sat Oct 11, 2003 11:26 am
- Location: Hamilton
by strx7 » Fri Jun 12, 2009 3:27 pm
or you pilot bearing in the end of the crank is grabbing meaning the inp0ut shaft is still actually turning despite having the clutch in.
Online Car Forums - Where Hui seems to take preference over Do-ey
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
HDJ81- 112AWKW @ 10psi), FC3S (Tarmac Spec 335rwhp@11psi), 3SGTE stroker - replacement body found.
Motorsport Bay of Plenty - http://www.mbop.org.nz
- strx7
- Toyspeed Member
- Posts: 3707
- Joined: Mon May 24, 2004 12:06 am
- Location: Tauranga
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 5 guests