Chrstchurch cert

[heinrich]

Hey guys,

Can anyone suggest a good place to take my car for a cert in christchurch? Need one for the MTEU > 1G conversion..

Ballpark figure for cost?

Thanks in advance

[rx7guy]

http://www.lvvta.org.nz/

I used Don Hoff. Will be at least $400 I think

[heinrich]

Awesome thanks! I'l check it out

[d1 mule]

don hoff is all good, i jush hung around ant talked smack with him while he did the cert, he's a good dude. Wayne martin is also good. Iv had 1 car cert'd by each and prob equally as easy but don was way more chilled out. they both have things they are anal about, wayne wont cert cars under 100mm, don will but all the suspension geometry has to be ok etc

[frost]

don hoff is all good, i jush hung around ant talked smack with him while he did the cert, he's a good dude. Wayne martin is also good. Iv had 1 car cert'd by each and prob equally as easy but don was way more chilled out. they both have things they are anal about, wayne wont cert cars under 100mm, don will but all the suspension geometry has to be ok etc

i found the exact same thing with them, wayne was anal about my bump stops being so "small" for the height of the car, and was easy about my wheel choice, but but don said they where sweet when i went for re-cert for other stuff, but had problems with my shaft loop, both good guys to deal with,

[heinrich]

Awesome .. thanks for the advice guys..

I'l try and fit in a time next week..

Cheers