Toyspeed.org.nz Message Board

by **Quint** » Sun Jun 13, 2010 12:25 pm

Anyone able to get this stuff for a reasonable price? After 2x 2" (OD) alloy doughnuts and ~2m of 2" straight for my IC lines. Prices I get given seem a little.... steep.

Cheers!

Website · by **Rick** » Sun Jun 13, 2010 1:26 pm

Theres tons of it for sale on trademe, how cheap do you want it?

by **Quint** » Sun Jun 13, 2010 1:33 pm

I've never managed to find alloy doughnuts.

Website · by **Rick** » Sun Jun 13, 2010 1:44 pm

Whats wrong with getting something like in the below link and chopping it to suit.

http://www.trademe.co.nz/Trade-Me-Motors/Car-parts-accessories/Nissan/Engines/auction-295518408.htm

by **evil_si** » Sun Jun 13, 2010 4:23 pm

try using donut

by **CelicaGT8** » Sun Jun 13, 2010 9:11 pm

I used the stuff on the trademe site above, its thin, not the best to weld, but it does the job, look at my corona on the link below if you want to see what it lookes like.

by **XSVWGN** » Sun Jun 13, 2010 11:40 pm

Quint wrote:Anyone able to get this stuff for a reasonable price? After 2x 2" (OD) alloy doughnuts and ~2m of 2" straight for my IC lines. Prices I get given seem a little.... steep.

Cheers!

Alloy donuts are normally around $45-$60 each. Alloy piping i got from urlich Aluminium and it was $40/ metre from memory.

Matt

by **Quint** » Mon Jun 14, 2010 11:50 am

Cheers lads, Yea was getting those prices, thought they were a bit high, but if thats the price, thats the price, dayim. Big step up from alloy flat bar.

by **tsoob** » Mon Jun 14, 2010 5:49 pm

stainless will be around the same $$

by **FYADUP** » Fri Jun 18, 2010 2:22 pm

Steel and Tube off cut bins are good - the pipes are fine, sometimes just have little chips or scratches, which you can polish out ofcourse.

Toyspeed.org.nz Message Board

Alloy tube for IC.

Alloy tube for IC.

Re: Alloy tube for IC.

Who is online