This is the measurement I need. Thanks in advance.
SW20 suspension height - SORTED
Moderator: The Mod Squad
6 posts
• Page 1 of 1
SW20 suspension height - SORTED
by iOnic » Sat Aug 14, 2010 2:39 pm
Does anyone know (or is anyone willing to measure) the height of a STOCK (suspension wise) SW20 from center of wheel to the guard lip? Trying to calculate how much lower than stock mine is
This is the measurement I need. Thanks in advance.
This is the measurement I need. Thanks in advance.
Last edited by iOnic on Sat Aug 14, 2010 2:51 pm, edited 1 time in total.
Faber est suae quisque fortunae
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
-
iOnic - Toyspeed Member
- Posts: 3736
- Joined: Fri Jun 25, 2004 6:31 pm
- Location: Melbourne VIC
by iOnic » Sun Aug 15, 2010 3:49 pm
Cheers 
Seems to vary from car to car. Got mine at 295 front and rear at the moment but the car is up in the air so suspension fully extended. Should settle a bit once on the ground.
Wanted to know so that I could figure out what size roll center adjusters I need to get my lower arms back to sensible angles
Seems to vary from car to car. Got mine at 295 front and rear at the moment but the car is up in the air so suspension fully extended. Should settle a bit once on the ground.
Wanted to know so that I could figure out what size roll center adjusters I need to get my lower arms back to sensible angles
Faber est suae quisque fortunae
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
-
iOnic - Toyspeed Member
- Posts: 3736
- Joined: Fri Jun 25, 2004 6:31 pm
- Location: Melbourne VIC
by RomanV » Sun Aug 15, 2010 9:20 pm
How do RCAs work when the steering arm is cast into the hub?
Obviously the steering arm angle needs to lower back down as well, if you're going to space the arms back down.
Obviously the steering arm angle needs to lower back down as well, if you're going to space the arms back down.
-
RomanV - Toyspeed Member
- Posts: 4915
- Joined: Wed Aug 13, 2003 12:17 am
- Location: West Auckland
by iOnic » Mon Aug 16, 2010 12:22 am
I've got aftermarket pillow ball outer tie rod ends that have the spacing built into the design similar to the ones below.
Faber est suae quisque fortunae
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
2009 Mazda3 MPS
2016 CFMoto 650NKs
2013 Hyundai IX35 Highlander
-
iOnic - Toyspeed Member
- Posts: 3736
- Joined: Fri Jun 25, 2004 6:31 pm
- Location: Melbourne VIC
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 18 guests