ae85 dash loom?

Nizbit · Post by **Nizbit** » Tue Sep 28, 2010 9:43 pm

hey guys, i have a few wires that i need to transfer to the sr20de loom,
just wondering if anyone has the pinouts or the diagrams to show me what they're for,

cheers

frost · Post by **frost** » Tue Sep 28, 2010 9:58 pm

the long green one is for emissions control ecu, can be unplugged without any ill effect,
you can find a useful.....
speed signal
rpm signal
batt+ and 12v switched power from it,

cant remember what the small one is for just yet, will have a look tomorrow,

matt dunn · Post by **matt dunn** » Tue Sep 28, 2010 10:16 pm

frost wrote:cant remember what the small one is for just yet, will have a look tomorrow,

i think it also went into the same emissions ECU.

Rick · Post by **Rick** » Wed Sep 29, 2010 3:34 pm

Just double check the wires to whats on your cluster, you can check by tracing it on the circuit board on the back of the cluster.

Nizbit · Post by **Nizbit** » Wed Sep 29, 2010 8:27 pm

ok sweet, hopefully i can work out the main ones i need (i.e. oil pressure, water temp) from the green plug,

Rick wrote:

Just double check the wires to whats on your cluster, you can check by tracing it on the circuit board on the back of the cluster.

is this looking at it from the back? i.e. no.1 will be on the white plug under the rev counter? it doesn't seam to match up

also where can i hook into for the rpm? cause i can't see it on that diagram
cheers

dusk93 · Post by **dusk93** » Wed Sep 29, 2010 9:38 pm

By looking at the diagram I vote pin #15 as RPM come from Tachometer.

Bling · Post by **Bling** » Wed Sep 29, 2010 9:39 pm

15, tacho

Edit beaten :lol:

Rick · Post by **Rick** » Wed Sep 29, 2010 9:51 pm

here is another pic for a analog to digital conversion again double check against your cluster.