Toyspeed.org.nz Message Board

Santa's TardMe Listings · by **Santa'sBoostinSleigh** » Sat Oct 02, 2010 12:23 pm

putting my blacktop back into my ae92, question: do i use the axle hangar bearing that was in the AE111 or do i use the driveshafts from the AE92?
we must have used the driveshafts last time, but i thought i should find out what the 'right way' is before i do it again

red car · by pc » Sat Oct 02, 2010 12:27 pm

If the hanger bearing will go in, use that. It will decrease torque steer and make the car easier to drive.

Santa's TardMe Listings · by **Santa'sBoostinSleigh** » Sat Oct 02, 2010 12:31 pm

as long as the ae111 axles are correct length then i guess its all good

anybody confirm?

by **touge_ae101** » Sat Oct 02, 2010 3:51 pm

yup they fitted in my ae101 and whynot put a blacktop in a couple ae92's and they fit fine.
plus hanger bearings stop the driveshafts getting their wobble on and snapping when hauling arse.

red car · by pc » Sun Oct 03, 2010 4:56 pm

touge_ae101 wrote:plus hanger bearings stop the driveshafts getting their wobble on and snapping when hauling arse.

4AGE can snap a drive shaft? :lol:

by **touge_ae101** » Sun Oct 03, 2010 9:24 pm

pc wrote:
touge_ae101 wrote:plus hanger bearings stop the driveshafts getting their wobble on and snapping when hauling arse.

4AGE can snap a drive shaft?

4age can do anything! all you need is a little imagination :lol:

OMG so shiny! · by **Dell'Orto** » Sun Oct 03, 2010 9:43 pm

pc wrote:
touge_ae101 wrote:plus hanger bearings stop the driveshafts getting their wobble on and snapping when doing roll backs.

4AGE can snap a drive shaft?

Edited for truth

Toyspeed.org.nz Message Board

AE92 w/20v axles etc

AE92 w/20v axles etc

Who is online