black top exhaust

[tim_blair]

i fabed up a new exhaust for my black top

i all ready had 2.5 from the rear to the cat and it was standed from the cat to the engine

what i have done is remove the cat and go with 2.5 all the way to the turbo outlet

my question is: there is a sensor after the cat, what is this sensor? and should it still be in the exhaust now that the cat is removed?

i currently have the sensor in

[sergei]

That sensor is cat. overheat sensor. Not needed if you don't have cat.
You can remove it and jump the plug (so there will not be light on dash complaining about it).

[Lurkin]

could be very keen to buy the factory exhaust if you still have it and it is unmolested....

[tim_blair]

kool ill remove that sensor

also yea the exhaust is in good condition except the flange for the cat has been nicely cut off

i can eaisly weld it back on for you

also i have cut off the mounts for the 02 sensor and the cat sensor mentioned earlier

i can weld the cat sensor mount back on and cut a new thread for an 02 sensor too

[Lurkin]

I'm looking for everything other than the 2-1 pipe + extractors...

[tim_blair]

all i have is the extractors
2>1 pipe and the cat