Toyspeed.org.nz Message Board

by **Shrike** » Wed Dec 21, 2011 2:06 pm

Anyone on here know of any panel beaters that have expirence with this basicly I want the rear 1/4 to look the same but be 67-70mm wider

I am widening the front gaurds as well but only 52-55mm (and im happy to do them myself as a f**k up just means a new set)

The rear 1/4s however if I screw up then it means I need a new shell

I am currently trying to located a rear cut and a spare crashed body (as long as the rear ends ok) to either use to have ago myself or give use in the widening

Cheers

OMG so shiny! · by **Dell'Orto** » Wed Dec 21, 2011 7:36 pm

Custom Autoworx in Upper Hutt did CNDYMN/STILYN's body I believe

by **Mr Ree** » Thu Dec 22, 2011 3:41 pm

Metal widebodys rule.

Its the long way to go about things, but its definitely the right way

by **Shrike** » Thu Dec 22, 2011 3:51 pm

Mr Ree wrote:Metal widebodys rule.

Its the long way to go about things, but its definitely the right way

the front gaurds will be made out of carbon eventually but ill start off in metal :p

by **CAMB01** » Thu Dec 22, 2011 6:22 pm

Dell'Orto wrote:Custom Autoworx in Upper Hutt did CNDYMN/STILYN's body I believe

Ryan who used to work there did the panel work. He is now my boss at a different business.
He has no spare time anymore to do anything like that.

by **~SlideWays~** » Fri Dec 23, 2011 9:01 am

CAMB01 wrote:
Dell'Orto wrote:Custom Autoworx in Upper Hutt did CNDYMN/STILYN's body I believe

Ryan who used to work there did the panel work. He is now my at a different business.
He has no spare time anymore to do anything like that.

Custom Autoworx down sized a lot didn't they?

by **CAMB01** » Fri Dec 23, 2011 12:04 pm

He just didnt want to be a panelbeater anymore.

Toyspeed.org.nz Message Board

WTB Panel beater with bare metal wide body expirence?

WTB Panel beater with bare metal wide body expirence?

Who is online