4AGE Bluetop

The place for all technical car discussions. If you haven't already, read our Disclaimer first!

Moderator: The Mod Squad

4AGE Bluetop

Postby spoonza6 » Sat Jun 01, 2013 2:25 pm

Just bought me an AE82 GT and come across an annoying problem

Up to when the water temp is half way, car runs fine

Once it's warmed up and running for a while whenever I slow down to stop it dies

Revs drop n it cuts out...

Where do I start?
User avatar
spoonza6
Toyspeed Member
 
Posts: 572
Joined: Mon May 26, 2008 9:48 am
Location: Auckland Airport, Auckland

Postby Lloyd » Sat Jun 01, 2013 2:49 pm

How high does it idle when it's dead cold?
User avatar
Lloyd
** Moderator **
 
Posts: 6195
Joined: Tue Oct 15, 2002 1:50 pm
Location: Dunedin

Postby spoonza6 » Sat Jun 01, 2013 3:00 pm

Around 2000rpm
User avatar
spoonza6
Toyspeed Member
 
Posts: 572
Joined: Mon May 26, 2008 9:48 am
Location: Auckland Airport, Auckland

Postby malc » Sat Jun 01, 2013 3:44 pm

All your vacuum lines connected up properly? could be something to do with the dash pot and throttle stop.
Image
User avatar
malc
Toyspeed Member
 
Posts: 711
Joined: Tue Sep 28, 2004 12:21 am
Location: Auckland

Postby touge_ae101 » Sat Jun 01, 2013 11:45 pm

Ecu water temp sensor + vacuum lines. replace. job done.
User avatar
touge_ae101
Toyspeed Member
 
Posts: 1730
Joined: Mon Sep 14, 2009 7:23 pm
Location: Palmerston North

Postby Vertigo » Sun Jun 02, 2013 12:14 pm

Yea I used to get big rpm blips with my BHG, the water temp sensor was getting bubbles of exhaust gas on it and freaking out. Look there.
TVIS just kicked in, yo!
AW11 200kw 4AGTE build Discuss
Image
Vertigo
Toyspeed Member
 
Posts: 1172
Joined: Mon Aug 29, 2005 12:03 pm
Location: Auckland

Postby spoonza6 » Sun Jun 02, 2013 4:10 pm

Vertigo wrote:Yea I used to get big rpm blips with my BHG, the water temp sensor was getting bubbles of exhaust gas on it and freaking out. Look there.


Ok so your car would cut out as you slowed down to a stop??
User avatar
spoonza6
Toyspeed Member
 
Posts: 572
Joined: Mon May 26, 2008 9:48 am
Location: Auckland Airport, Auckland

Postby xsspeed » Sun Jun 02, 2013 4:31 pm

Check other things before assuming bhg
if you leave it idling so it gets hot do the revs drop to around 900 or so or does it stall once the Cold injector drops out
xsspeed
Toyspeed Member
 
Posts: 3946
Joined: Tue Aug 21, 2007 5:56 pm
Location: Auckland


Return to Tech Questions

Who is online

Users browsing this forum: No registered users and 13 guests